499722
6
Zoom out
Zoom in
Previous page
1/8
Next page
14
11.3 Electronic control panel alarms
When the electronic control panel detects the boiler is running dry, all LEDs of key pad start blinking.
When the control panel detects problems on the flowmeter, the LED of the dose pushed starts to flash.
The product dispense is automatically interrupted after 5 minutes (Time-out). The led keeps on blinking
until a new selection is made.
12. Heating-up liquids
a) Place the steam wand, -see (1) Fig. 1-, above the tray and open a bit the steamer knob, -see (2) Fig. 1-
, in order to allow condensed water drops go out.
b) Turn the steam knob.
c) Place the steam wand inside the liquid wanted to be heated up.
d) Open up the steam knob and it will start to heat the liquid ( do not take it out from the liquid until closed,
you could be injured with the steam).
e) Once this process has finished, put the steam wand on the tray and open up the steam knob to clean
leftovers of milk or other liquids, inside the steamer. Turn the knob and clean the outside of the steamer with a
damp cloth.
13. Hot water for infusions
Place the recipient under the water tap, -see (13) Fig. 1-, where you want to have hot water.
Open up the water knob, -see (3) Fig. 1,- until you have the desired volume of water.
Close it down.
14. Coffee machine with built-in grinder
Previous operations before starting-up the coffee grinder:
a) Check the bean hopper (2) is correctly placed.
b) Place the bean hopper gate (3) in a locked position, in order to avoid the pass of the coffee beans to
the grinder, just pressing it.
c) Lift up the bean hopper (2) lid (1), fill the bean hopper with beans and close it again
d) Slide the bean hopper gate (3) to a position allowing the coffee getting into the grinder, pull from the
bean hopper gate.
How to obtain a ground coffee dosage:
a) Place the portafilter over portafilter holder (7), which it is just under the ground coffee outlet.
b) Pull from the ground coffee dosage device lever (9) towards you in order to obtain a dosage and leave
the coffee dosage device lever free.
c) Place the portafilter under the coffee tamper (9) and push it upwards in order to compact the coffee.
Adjusting the grinding degree of coffee:
You can obtain two grinding degrees (thin ground coffee/coarse ground coffee).
a) If you want to obtain thin ground coffee. Maintain pressed the millstone trigger (5) in order to turn
right the setting grind wheel (4), then set it free.
b) If you want to obtain a coarse ground coffee. Maintain pressed the millstone trigger (5) in order to
turn left the setting grind wheel (4), then set it free.
1 BEAN HOPPER LID
2 BEAN HOPPER
3 BEAN HOPPER GATE
4 COFFEE GRINDING ADJUSTMENT DISK
5 GRINDING TRIGGER
6 GROUND COFFEE DOSAGE DEVICE LID
7 GROUND COFFEE DOSAGE DEVICE
8 GRINDER ON/OFF SWITCH
9 DOSAGE DEVICE LEVER
10 COFFEE TAMPER
11 GROUND COFFEE OUTLET
1
2
3
4
5
6
7
8
9
10
11
ENGLISH
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Expobar Ruggero 2 GR Compact at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Expobar Ruggero 2 GR Compact in the language / languages: English as an attachment in your email.

The manual is 2,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info