7.3.3 If connected to a audio receiver using the coaxial or optical connection:
1. Use the navigation buttons to go to ‘Setup’ and press the ‘OK’ button.
2. Select ‘Audio’.
3. The first option displayed is the ‘Preferred audio language’ here you can set what
audio language the EM7480/EM7485 should start to use (if available).
4. If the media player will be used mainly during night-time, the ‘Night Mode’ can be
set to ‘ON’ or ‘Comfort’. When set to ‘On’, low-level audio content such as dialog
will be increased making it easier to hear at low volume levels. When set to
‘Comfort’, the intensity of higher-level audio content will also be reduced.
5. Select ‘SPDIF Output’ and press the ‘OK’ button. Set ‘SPDIF Output’ to ‘RAW’.
6. Select ‘Surround Sound’ and press the ‘OK’ button. Select ‘5.1 CH’ or ‘Undefined’
and press the ‘OK’ button.
7. The last item is ‘Lip Sync’. Usually, ‘AUTO’ is the default setting and is the
recommended setting. Only set the ‘Lip Sync’ option if you experience delay in
audio playback. The maximum setting for lip sync is 500. However, some SPDIF
receivers also have a ‘Lip Sync’ option. It is advisable to use the lip sync option on
the receiver, since most receivers are able to delay and speed up the sound.
7.4 Setting up the network
During the wizard, the initial network setup was available. The network settings can be
changed afterwards if necessary. The EM7480/EM7485 can also connect to your
wireless network by connecting an EM4576/4579 wireless USB stick. During the next
chapter we will explain how wired network settings can be changed and how to setup
a wireless connection.
7.4.1 Wired connection - Automatically using DHCP
1. Use the navigation buttons to go to ‘Setup’ and press the ‘OK’ button.
2. Select ‘Network’.
3. Select ‘Wired Lan Setup’ and press the ‘OK’ button.
4. Choose ‘DHCP IP (AUTO)’ to automatically obtain an IP-Address. Press the ‘OK’
button to confirm.
5. Choose ‘DNS (auto)’ and press the ‘OK’ button, after which the notification ‘Save
network setting appears’. Select ‘Yes’ and press the ‘OK’ button.
6. The connection will be tested. If correct, the notification ‘Connected’ will appear.
Also, an ‘IP-Address’ and ‘Submask’ will be shown. Press the ‘OK’ button.
7. Press the ‘Home’ button to return to the main menu.
