708677
3
Zoom out
Zoom in
Previous page
1/4
Next page
3
Testing
(1)
Go to System, and select ARM
(2)
Wait for 30 secs, then separate the detector from the magnet (at least 3.5cm
distance apart).
(3)
If the test is successful the system will trigger an alarm (alarms are listed in
“Events”).
Notes: It is necessary that the system is powered and connected to internet.
(4)
If the test is unsuccessful, please check the troubleshooting section.
Mounting
1.
Mount the Magnetic Detector in dry interior locations only.
2.
Do not place the unit near combustible substances or any source of heat, e.g.
fires, radiators, boilers etc.
Note: Mounting the detector to a metal frame or within 1 meter of metalwork (e.g.
radiators, water pipes) may affect radio range of the device. Please use plastic or
wooden spacers to separate the detector and metal surface when required.
Installation
1.
Fit the magnet on the moving part of the door / window opposite the detector (or
vice versa, if necessary). Use the provided self-adhesive tape to secure them in
place.
2.
Make sure the parallel gap between the magnet and detector is less than 20mm
and that they are aligned. An alarm will be triggered if the gap is greater than
35mm.
3.
Perform the test using the same steps described in Operation & Testing section
above to ensure the unit is working properly.
Maintenance
1.
Low Battery: When the battery becomes low, the detector will report back to the
gateway every 20 minutes. If the door or window is open the LED will flash to
indicate low battery condition to the user.
2.
If the battery needs to be changed, please insert the batteries at a 45° angle as
shown below.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro AS80MA11 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro AS80MA11 in the language / languages: English as an attachment in your email.

The manual is 0,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info