708653
1
Zoom out
Zoom in
Previous page
1/3
Next page
INTRODUCTION ELRO HOME PIR PET-IMMUNE MOTION SENSOR AG40PP11:
The PIR Pet-immune Motion Sensor AG40PP11 is designed for use with the AG4000 ELRO Home
Alarm System.
PIR Motion Sensor: Tamper
PIR sensors are designed to detect movement. This sensor features Test
pet immunity however, meaning that your pet moving around will not cause
false alarms.
Installing your home PIR Motion Sensor:
First, the battery has to be inserted into the device. To do this, first unscrew the screw at the bottom of
the sensor so you can remove the back plate. After removing the back plate, place the CR123A 3V
lithium battery in the sensor in the way shown in the picture above. Under normal conditions, the battery
will typically have a life of 3 years. After powering on, the PIR will warm-up for 2-3 minutes. The LED
will flash during this time. When the warm-up has finished, the LED will stop flashing. Next press and
hold the small black test button for at least two seconds to make the PIR detector enter test mode. When
in test mode, if you walk around the area the unit is covering, the LED will flash for 0.5 second (normally,
the LED will not flash when it detects movement). The control panel will also be notified of movement
being detected. If no movement is detected for more than 3 minutes, the PIR detector will exit test mode
and enter normal mode again.
Note: Under test mode the LED will flash when the PIR detector is triggered. The LED flash in test mode
only lasts for 0.5 second. When the unit has a low battery, the LED will flash for one second. In normal
mode the PIR will only send a new signal after two minutes have passed since being triggered.
Pet immunity:
The sensor comes with a pet immunity mechanism immunity mechanism so that small pets or other
animals will not trigger the detector and cause false alarms. The mechanism works by detecting
height/length, therefore a pet that is taller than 60cm or longer than 90cm will trigger the PIR motion
sensor. You can see this in the image shown below.
Mounting the PIR motion sensor:
When determining where to place the detector, there are various factors to consider:
1. The detector must not be placed facing a window that lets in direct sunlight. PIR detectors are
not suitable for use in sunrooms or greenhouses.
2. Do not place the detector in a place where a ventilator is in its line of sight.
3. Do not place the detector directly above a heat source (e.g. fire, radiator, boiler, etc.)
4. Where possible, mount the detector in the corner of a room, so that the logical path of an
intruder would cut across the detection pattern. PIR detectors are better at detecting
movements across their field of view, than at detecting movement directly towards or away
from the unit.
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Elro AG40PP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Elro AG40PP in the language / languages: English as an attachment in your email.

The manual is 0,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Elro AG40PP

Elro AG40PP User Manual - German - 3 pages

Elro AG40PP User Manual - Dutch - 6 pages

Elro AG40PP User Manual - French - 3 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info