716474

Dobar 50132 Manual

5
Zoom out
Zoom in
Previous page
1/6
Next page
Instruction Manual
50132 Automatic 6 Meal LCD Clock Pet Feeder
Features
• 12 or 24 hour clock display
• 6 second personal voice message recorder
• Personal Voice message calls your pet when its feeding time
• Food Bowl rotates according to your set time
• The 6 Feeding times can be set for any time of day or night
• C size alkaline batteries (4pc’s required) last over 1 year
• Red LED indicates Low batteries
• Extra compartment atop for ice-pack or water
Control Panel Keys
• MODE - switches between clock or feeding time display. Also increases clock
time during clock / feeding time Set mode
• SET – enters settings mode. Also conrms the time you enter and advances to
next setting
• START NOW – starts the feeding timer immediately
• START TOMORROW- starts the feeding timer the next day
• REC – records your personal voice message
• PLAY – plays back your recorded voice message
• ON SWITCH – turns the feeder on / o. For when the feeder will not be used
for an extended period of time. Turning this switch o will RESET all time and
feeding settings
Getting Started
4. Carefully turn the pet feeder upside down. Remove both battery doors by
squeezing the two tabs and gently pulling each door away
5. Keep the ON switch set to OFF
6. Insert four C size alkaline batteries into the battery tray. Do NOT use old or
-cheap- carbon batteries
7. Close the battery doors, rotate the feeder right-side up and switch ON
8. The feeder will cycle one time until “12:00” is on the LCD display
Note: Your pet feeder makes the food available in this sequence:
Tray 1, Tray 2, Tray 3 to Tray 6. When you want only one feeding, you
should ll only Tray 1; for only 2 feedings, ll Trays 1 and 2 and so
on.
General Operation
Filling the bowl with Food
1. Please refer to the section, Disassembly, to open the LOCK-(F) and remove LID-
(A) and SLIDE COVER-(B).
2. Pour pet food into the feeder bowl food trays (1,2,3,4,5,6) being careful not
to over-ll each food tray past the bowls edge as this can cause the feeder to
malfunction.
3. Please refer to the section, Assembly, to replace the SLIDE COVER-(B) and LID-(A)
and LOCK-(F).
4. Make sure the SLIDE COVER-(B) locks into position with the LID-(A).
Setting the current Clock Time
1. During Clock display mode, press and hold the SET key for (2 seconds) to enter
Clock SET mode. The hour number will now be blinking
2. Press the MODE key to increase the hour. Once you have set the hour, press the
SET key to conrm the hour. The minute number will now blink
3. To change the minute number, press the MODE key to increase the minute. Once
you have set the minute, press the SET key to conrm the minute. Both the hour
and minute numbers will now blink
4. If needed, Press the MODE key to change between 12 or 24 hour time
5. Press the SET key to conrm your current time setting and the numbers will stop
blinking
Setting the Feeding Time
1. After setting the clock time, press the MODE key one time. (1 1) will show on
the display. This is feeding time display mode.
2. Now press and hold the SET key for (2 seconds) to enter Feeding-time SET
mode. Feeding will start from the rst feeding number & time. The 1st digit
represents the feeding number (Food Tray 1).
3. The hour digits will now blink (2nd and 3rd digit). Press the MODE key to increa-
se the time, then press the SET key to conrm the time you set.
4. After conrming the 1st feeding time, the next feeding number & time will
show on the display. (1st digit will change to the next feeding number, e.g. Food
Tray 2 or 3 or 4 or 5 or 6 and back to 1) To change the feeding time, repeat step-3.
5. Repeat step-3 until all 6 feeding times for each Food Tray are set. The display will
change back to clock display mode when all 6 feedings have been set.
Program examples:
1. Feed once a day at 13:00hr (24hrs display) and feed for 6 days
Feed time 1 & 2 & 3 & 4 & 5 & 6 all equal = 13:00hr
2. Feed twice a day at 10:00 and 20:00 and feed for three days
Feed time 1 = 10, feed time 2 = 20, feed time 3 = 10, feed time 4 = 20, feed
time 5 = 10 and the last time 6 = 20
3. Feed three times a day at 6:00am, 12:00 and 18:00 (6:00pm)
Feed time 1 = 06, feed time 2 = 12, feed time 3 = 18 and so on…
1
st
digit
2
nd
digit
3
rd
digit
Feeding
Number
Feeding
Time
Review and Start the feeding timer
1. Use the MODE key to cycle through clock and your set feeding times.
2. Press the START NOW key to start the feeding timer immediately. The bowl will
rotate to the pre-set starting position (Tray 6) and your recorded message will
play once. The BELL icon will now be On
3. Or press the START TOMORROW key and the feeding timer will start at
0:00-Midnight. The bowl will rotate to the pre-set starting position (Tray 6) and
your recorded message will play once. The BELL and Zz icon will now be On
Record Voice Message to be played at feeding timest
1. Press and hold the REC key, the Red LED will turn on
2. Speak your message. You have up to 6 seconds
3. When nished release the REC key
Play back recorded Voice Message
1. Press the PLAY key
2. Your recorded message will now play
3. At each Feeding your recorded message will play back 3 times
Battery Replacement
Change all batteries when the Red LED (Low battery indicator) ashes. Use only new
Alkaline batteries.
Disassembly and Assembly
Your Automatic Pet Feeder comes pre-assembled. However, there may be times when
you wish to remove some parts of the bowl for cleaning, load food, or to replace the
batteries.
Disassembly (refer to diagram)
Lock-(F) – Push in the middle of each lock and pull up using your ngertips. Now
remove the lid-(A), being careful not to pull the lid o from only one side as this can
damage the locking pins. The slide-cover-(B) easily lifts o, as does the food bowl-(D).
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Dobar 50132 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Dobar 50132 in the language / languages: English, German as an attachment in your email.

The manual is 0,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info