782542

DGFlow Presflo Manual

1
Zoom out
Zoom in
Previous page
1/16
Next page
EN
PRESFLO
®
is a device
that starts and stops the
pump to which it is fitted,
thus replacing traditional
pressure switch / surge tank
systems.
The pump is started when,
as a tap is turned on, the
pressure within the system
drops below the “start-up
pressure” ( Pm), and is
stopped when the flow rate
required is zero or less than
the “shut-off flow rate” (Qa).
PRESFLO
®
’s electronics
protect the pump against
unsuitable operating
conditions such as dry
running or repeated start-
ups due to leaks.
IT ES FR
User’s
manual
PRESFLO
®
è un
apparecchio che avvia ed
arresta l’elettropompa su
cui è installato sostituendo
i tradizionali sistemi a
pressostato / autoclave.
La pompa viene avviata
quando, all’apertura di un
rubinetto, la pressione
dell’impianto scende sotto
la “ pressione di marcia “ (
Pm), e viene fermata
quando la portata richiesta
si azzera o scende al di sotto
della “ portata di arresto “
(Qa).
L’elettronica di PRESFLO
®
protegge la pompa da
condizioni di funzionamento
anomale come la marcia a
secco o gli avviamenti
ripetuti dovuti a perdite
nell’impianto.
PRESFLO
®
est un
appareil qui démarre et
arrête l’électropompe sur
laquelle il est monté et
remplace les dispositifs
classiques à pressostat /
autoclave.
La pompe démarre lorsque,
après ouverture d’un
robinet, la pression de
l’installation descend sous
la « pression d’exercice »
(Pm), et s’arrête lorsque le
débit requis est effacé ou
descend sous le “débit
d’arrêt”(Qa).
L’électronique de PRESFLO
®
protège la pompe contre les
dysfonctionnements comme
le fonctionnement à sec ou
les démarrages à répétition
provoqués par des pertes
dans l’installation.
Manuale istruzioni
IT
EN ES
FR
DGFLOW srl
Via Emilia, 5 - 46030 Bigarello (Mantova) Italy
tel. +39 0376 340922 - fax. +39 0376 249525
info@dgflow.it - www.dgflow.it
PRESSOFLUSSOSTATO
ELETTRONICO
Manual de
instrucciones
CONTROLADOR DE
BOMBA ELECTRÓNICA
Notice d’instructions
CONTROLEUR ELECTRONIQUE
DE POMPES
PRESFLO
®
es un
aparato para hacer arrancar
y parar la electrobomba en
la que se instala
sustituyendo los
tradicionales sistemas de
presostato/autoclave.
La bomba arranca cuando,
al abrir un grifo, la presión
de la instalación cae por
debajo de la “presión de
marcha" (Pm), y se para
cuando el caudal solicitado
se pone a cero o cae por
debajo del “caudal de
parada" (Qa).
La electrónica de PRESFLO
®
protege la bomba de
condiciones de
funcionamiento anómalas
tales como la marcha en
seco o los arranques
reiterados debidos a
pérdidas en la instalación.
00106600A rev.1
1 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for DGFlow Presflo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of DGFlow Presflo in the language / languages: English, French, Italian, Spanish as an attachment in your email.

The manual is 0.38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info