ENG-13
4.1.13 Set Video Length
The following shows how to set video length to 30 Seconds, provided that the
previous value is 10 Seconds:
a) Press MENU to display the setting menu.
b) Press DOWN to select Video Length.
c) Press down the select switch to save the current setting, then press
MENU to return to info display.
Press MENU to cancel setting and exit.
4.1.14 Set Video Sound
The following shows how to turn off the sound of the video:
a) Press MENU to display the setting menu.
b) Press DOWN to select Voice.
c) Press RIGHT to display the VOICE setting Interface.
4.1.15 Set Delay
This parameter means that how long the PIR (Passive Infrared motion sensor) will
be disabled after each triggering in ON mode. During this time the PIR of the
device will not react to the motion of human (or animals). The minimum interval is
5 seconds, it means the PIR works all the time and media is taken almost
continuously. The maximum interval is 30 minutes, it means the PIR will be
disabled for 30 minutes after each triggering. The default value is 5 seconds.
The following shows how to set PIR Triggering Interval Time as 1 minute provided
that previous option is 5 seconds.
a) Press MENU to display the setting menu.
b) Press DOWN to select Delay.
c) Press RIGHT to enter in to the interval setting.
d) Press DOWN to select 1 minute.
e) Press down the select switch to save the current setting, then press
MENU to return to info display.
Press MENU to cancel setting and return to info display.
4.1.16 Set Timer
This parameter defines a certain time lapse in a day when The Camera can be
triggered. In the rest of the time the device is shut off. The effective value of the
hour ranges from 0 to 23 while the minute ranges from 0 to 59.
Provided that the camera should work from eight a.m. to five p.m., the steps are
as follows:
a) Press MENU to display the setting menu.
b) Press DOWN to select Timer.
c) Press RIGHT to select item, press UP or DOWN to change the value until
the start time changes to 8 and the stop time changes to 17.
d) Press down the select switch to save all current setting, then press MENU
to return to info display.
Press MENU to return to previous menu.
4.1.17 Enter Password
If the password setting is selected as On, after switching on the camera, the LCD
screen on camera will prompt to enter password. The default password is off. It
can be changed where the steps are as following:
a) Press MENU to display the setting menu.
b) Press DOWN to select Password.
c) Press Up to select On, then press Right to select 4 numbers as password.
d) Press OK to save the current setting, then press MENU to return to info
display.
e) The LCD screen will prompt to enter password next time you switch on
the camera.
