615478
3
Zoom out
Zoom in
Previous page
1/62
Next page
ENG 2
ENGLISH
ENG 3
ENGLISH
Description
Parent Unit – Volume
Parent Unit – Radio signal strength
Parent Unit – Main menu
The pairing phase must be completed within 30 seconds. If you are unable to
complete its on time, wait until the red LED on the camera stays light ON, then
turn o the camera and try again. Once successfully completed there is no need
to repeat the pairing phase.
This chapter provides a description of parent unit and baby unit.
Parent Unit - Description
1.Power button (ON/OFF)
2.LCD Panel
3.Channel radio (1-2-3-4)
4.TALK button
5. and OK buttons
6.Speaker
7.RESET button
8.Le side: power connector and LED
9.Right side: AV OUT connector
10.Clip
11.Radio signal strength icon
12.Channel icon
13.Battery charge icon
Parent Unit – Talk and Listen function
This appliance has a dual connection between parent unit and baby unit (2 ways). This means
that you can speak with your baby by talking in the microphone inside the parent unit and your
voice will be heard by the baby through the speaker inside the camera, so you can calm him
without moving.
To talk with your baby please follow these steps:
1.Please check if the wireless camera is active then power ON the parent unit.
2.Press and hold the TALK button then start to speak near the parent unit.
3.Release the TALK button to listen your baby.
To set the volume in the parent unit, please follow these steps:
1.Power ON the parent unit.
2.Press or buttons and select your desired volume level. It is possible to set a volume level
from 0 to 9. The selected value will be stored in the parent unit.
2
1
3
4
5
10
9
6
7
8
11
12
13
LCD Panel
If you select “0” (zero) the audio in the parent unit will be disabled.
If the parent unit is near the baby unit you could hear a noise as “whistle”. To
x this inconvenience please place the wireless camera far from parent unit or
decrease the volume.
The LCD panel shows the radio signal strength icon.
Parent Unit – Battery
The parent unit has inside a rechargeable battery. At the rst use it is recommended to fully
charge the battery by connecting the power adapter to parent unit and t it in a compatible
power outlet.
Full charge. The battery life is approximately 5 hours.
To enter in the main menu, power ON the parent unit and press the OK button.
Listed below the options available:
1.ZOOM IN/OUT
2.BABY UNIT VOLUME
3.EFFECT SET
4.SETUP
5.TV OUT
Press or buttons to select an option and press OK button to conrm the selection.
Good signal. This is the optimal condition to use the appliance.
Low signal. There is communication between parent unit and baby unit, but you
risk to loose the signal. It is recommended to change the position of baby unit or
decrease the distance between parent unit and wireless camera.
No signal. There is not any communication between parent and baby unit.
NOTE
NOTE
Completely discharged battery. Charge the battery by connecting the parent unit
to the power adapter.
Low charge. The battery is very low and therefore will need to connect the power
adapter soon.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denver SC-17 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denver SC-17 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info