584591
17
Zoom out
Zoom in
Previous page
1/18
Next page
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other components operating properly?
If this unit does not operate properly, check the items listed in the table below. Should the problem persist,
there may be a malfunction.
In this case, disconnect the power immediately and contact your store of purchase.
Symptom Cause Countermeasure Page
Power does not
turn on, or turns
off directly after it
was turned on.
Connection of the power cord is
faulty.
Check that the power plugs are
securely inserted into the POA-
A1HDCI’s AC inlets and the wall
power outlet.
12
No sound is
produced from
speakers.
Connection with the input
devices or connection of the
speaker cables is faulty.
Check the connections. 5, 9 ~ 11
Power turns off
suddenly and
power indicator
flashes red.
Protection circuit activated due
to rise of internal temperature.
Core wires of two speakers are
touching each other or a core
wire is sticking out of the terminal
and touching the set’s rear panel,
activating the protection circuit.
Speakers with an impedance
other than specified are being
used.
Set is damaged.
Turn off the power, wait for the
set to fully cool down, then turn
the power back on.
Place the set in a well-ventilated
place.
First unplug the power cord,
then twist the core wires tightly
or terminate the speaker cables,
then reconnect.
Use speakers with the specified
impedance.
Turn off the power and contact a
DENON service center.
5
5
5
9 ~11
Troubleshooting
n
Power amplifier section
Rated output:
Normal connections:
L1 / R1:
150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
300 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
L2 / R2:
150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
300 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
L3 / R3:
150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
300 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
L4 / R4:
150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
300 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
L5 / R5:
150 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
300 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Bridge connections:
L1 + L2:
300 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
500 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
L3 + L4:
300 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
500 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
L5 + R5:
300 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
500 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
R1 + R2:
300 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
500 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
R3 + R4:
300 W (8 Ω/ohms, 20 Hz ~ 20 kHz with 0.05 % T.H.D.)
500 W (4 Ω/ohms, 1 kHz with 0.7 % T.H.D.)
Frequency response:
10 Hz ~ 100 kHz (8 Ω/ohms, +1, –3 dB (at 1 W) )
Speaker output connectors: A or B 4 ~ 16 Ω/ohms
A + B 8 ~ 16 Ω/ohms
Bi-wiring 4 ~ 16 Ω/ohms
n
General
Power supply: AC 120 V, 60 Hz
Power consumption:
12 A
0.3 W (Standby)
Maximum external dimensions:
434 (W) x 281 (H) x 530 (D) mm (17-3/32” x 11-1/16” x 20-55/64”)
Weight: 60 kg (132 lbs 4 oz)
Specifications

Getting Started Connections and Settings Operations Troubleshooting
1.POA-A1HDCIEU.indd 17 2008/01/18 11:07:29
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Denon POA-A1HDCI at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Denon POA-A1HDCI in the language / languages: English as an attachment in your email.

The manual is 5,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info