C ollection
34
•press the OK button. Descaler runs off from the hot water spout into the container below.
The appliance displays:
APPLIANCE IN DESCALE
• the descale programme automatically performs a series of run offs and pauses to remove lime scale
deposits from inside the coffee maker.
• After about 30 minutes, the appliance displays:
RINSING FILL TANK
The appliance must now be rinsed through to eliminate residues of descaling solution from inside the applian-
ce.Proceed as follows:
• empty the water tank, rinse and fill with clean water.
•Reposition the tank.
• Empty the full container and then put it back under the hot water spout.
•Press the OK button. Hot water is run off from the spout into the container below and the appliance dis-
plays:
RINSING
•When the water tank is empty, the appliance displays the message:
RINSING COMPLETE PRESS OK
•Press the OK button and refill the water tank with clean water.
•The descale programme is now terminated and the appliance is ready to make coffee again.
NOTE: if the descaling cycle is interrupted before completion, the appliance continues to display the descale
message and the programme must be started again from the beginning. Empty the water tank, rinse, fill with
clean water and run off a cup of hot water.
IMPORTANTE FAILURE TO DESCALE THE APPLIANCE REGULARLY INVALIDATES THE GUARANTEE.
17.4 C
hanging coffee temperature
To change the temperature of the coffee, proceed as follows:
•Press the P button, then press the button (corresponding to the symbol flashing on the display)
repeatedly until the menu arrow is on:
HIGH TEMPERATURE
•Press the button (corresponding to the SET symbol flashing on the display) until the appliance dis-
plays the required coffee temperature.
Note: to obtain hotter coffee, seel also section 6, note 3, page 28.
•Press the OK button to confirm the temperature selected;
•Press the P button (corresponding to the ESC symbol flashing on the display) to exit programming mode
or to change other parameters.
17.5 C
hanging the length of time the appliance remains on
The appliance is factory preset to go off automatically one hour after the last coffee has been made.
The number of hours the appliance remains on (max. 3) can be increased as follows:
•Press the P button, then press the button (corresponding to the symbol flashing on the display)
repeatedly until the menu arrow is on:
OFF AFTER 1 HOUR
•Press the button (corresponding to the SET symbol flashing on the display) to change the number of
hours the appliance remains on.
•Press the OK button to confirm the value;
•Press the P button (corresponding to the ESC symbol flashing on the display) to exit programming mode
or to change other parameters.
