653705
19
Zoom out
Zoom in
Previous page
1/20
Next page
TROUBLES
POSSIBLE
CAUSES
SUGGEST
REMEDIES
1.
Unit does
not
Start
when
Pressing
on/off
Button
- P1
appears
in the
display
window
Drain the
water
in the
bottom
tray.
-
Room temperature
is
lower
than
the set
temperature.(Cooling
mode)
Reset
the temperature.
2.
Not cool
enough
-
The windows
or
doors
in
the
room
are not
closed.
Make sure
all the
windows
and
doors
are closed.
-
There
are
heat sources inside
the
room.
Remove
the
heat sources
if possible.
-
Exhaust
air
duct
is not
connected
or
blocked.
Connect
the
duct and
make
sure
it
can function properly.
-
Temperature setting
is too high.
Decrease
the set temperature.
- Air
filter
is
blocked
by dust.
Clean
the air filter.
4.
Noisy
or vibration
-
The ground
is not
level
or not flat
enough.
Place
the
unit
on a
flat,
level
ground
if possible.
5.
Gurgling
sound
-
The sound comes from
the flowing
of the
refrigerant inside
the
air-conditioner.
It is normal.
6.
Power shut off at
Heating mode
-
The automatic over
heat
protection function. When
the
temperature
at the air outlet
exceed 70
O
C/158
O
F,the
device
wi ll stop.
Switch
on
again after
the unit
has cool
down.
CARE AND MAINTENANCE
Air filter
(take out)
Fig.24
Air filter
(install)
CARE AND MAINTENANCE
IMPORTANT:
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the damaged power supply cord must be replaced with
a new power supply cord obtained from the product
manufacturer
and not repaired.
1. Air filter
- Clean the air filter at least once every two weeks to prevent
inferior fan operation because of dust.
- Removal
Take the air filter out along the arrow direction (Fig.24).
- Cleaning
Wash the air filter by immersing it gently in warm water
(about 40
O
C/104
O
F) with a neutral detergent. Rinse the filter
and dry it in a shady place.
- Mounting
Install the air filter after cleaning (see Fig.25).
TROUBLE
SHOOTING
TROUBLESHOOTING
TIPS
Fig.25
NOTE:
The grill and the air filter are connected and can be
separated.
2. Unit enclosure
- Use a lint-free cloth soaked with neutral detergent to clean
the unit enclosure. Finished by a dry clean cloth.
3. Unit idle for a long time
- Remove the rubber plug at the back of the unit and attach
a hose to drain outlet
.
Place
the
open
end of the hose
directly
over the
drain area
in your
basement
floor
(See Fig.22 & 23).
- Remove the plug from the bottom drain outlet, all the water
in the bottom tray would drain out (See Fig.24).
- Keep the appliance running on FAN mode for half a day in
a warm room to dry the appliance inside and prevent mold
forming.
- Stop the appliance and unplug it, wrapped the cord and
bundle it with the tape. Remove the batteries from
the remote
controller.
- Clean the air filter and reinstall it.
14
15
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Climadiff Clima 19 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Climadiff Clima 19 in the language / languages: English, French as an attachment in your email.

The manual is 2,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info