816449
3
Zoom out
Zoom in
Previous page
1/10
Next page
3
Assembly & Operation
To fit or replace the cutting wheel, first take out the removable
side of the cutting table. Remove nut and washer using the
wrench provided.
Position the blade against the black flange ensuring that the
directional arrow on the blade matches that on the cutting
table. Replace the front flange and nut. Do not over tighten!
Before replacing table top, fasten guard support in the slot
behind the blade opening using the screws provided. Attach
the blade guard to the support using bolt and wing nut.
Fill the reservoir to a point just below the overflow opening at
the top of the drain plug. Replace cutting table. Check
frequently during use – do not allow the blade to run dry.
Operating Instructions
Straight cuts
Place the Rip Guide on the preferred side of the table top and
line up with the rule edge to the required measurement of the
tile to be cut. When correctly aligned, lock in place by pushing
the adjuster firmly downwards.
Position the tile on the table top.
Switch on the machine.
Maintain an even pressure, hold the tile against the cutting
guide and push steadily through the cutting wheel. When the
cut is complete, then switch off the machine.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Carat Microcoup 180 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Carat Microcoup 180 in the language / languages: English, Dutch as an attachment in your email.

The manual is 2.47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info