509703
198
Zoom out
Zoom in
Previous page
1/200
Next page
LinkStation User Manual 197
Appendix
Troubleshooting
Cannot Setup
The following section lists typical occurrences and causes when you cannot setup the LinkStation
by using LinkNavigator or cannot use LinkStation even after nishing setup,
Occurrence: The message "Cannot find LinkStation", "No available LinkStation was found", or
"Setup cannot be completed" is displayed.
Cause 1. An Ethernet cable is not connected.
Reconnect the AC Adapter and the Ethernet cable, and turn on the LinkStation again.
Cause 2. The rewall is enabled, or software running in the background is installed.
Disable the rewall or uninstall software which enables the rewall, and try to search for the
LinkStation again.
Cause 3. Both wireless and Ethernet Adapter are enabled.
Disable any adapters other than the Ethernet Adapter to connect to the LinkStation.
Cause 4. The defective Ethernet cable or the connection is not stable.
Change a port on the hub to connect or replace the Ethernet cable.
Cause 5. Your Ethernet Board, card, or adapter is malfunctioning.
Replace a Ethernet Board, card, or adapter.
Cause 6. The Ethernet Board you are using or the transfer mode of the hub is not set.
Change the Ethernet Board, or change the transfer mode to [10M half-duplex] or [100M
half-duplex].
Some Ethernet Boards and hubs may not be connected to the network properly if the
transfer mode is set to [Auto Negotiation].
Cause 7. There is a network bridge.
If any network bridge which is not used, delete them.
Cause 8. You are searching from a dierent network.
You cannot search for the LinkStation over network segments. Connect the LinkStation to
the same segment as the computer you use for search.
198


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Buffalo NAS LinkStation at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Buffalo NAS LinkStation in the language / languages: English as an attachment in your email.

The manual is 13,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info