451227
2
Zoom out
Zoom in
Previous page
1/6
Next page
Scanner Cover
Scanner Cover
Release Lever
PUSH
PUSH
PUSHPUSH
White Shipping Cover
White Shipping Cover
A. Check that the power is turned on (by plugging in the power cord).
The LCD shows:
CHECK CARTRIDGE
B. Open the Scanner Cover of the MFC by pulling the scanner cover
release lever toward you and lifting the scanner cover. After a few
seconds, the print head will move left to its replacement position.
7
Opening
Peel in the direction
away from you!
Don't touch
this part
WARNING
If ink gets in your eyes, rinse them with water immediately and if
irritation occurs, consult a doctor.
We recommend that you install the ink cartridges from left to right in
this order: Black, Cyan, Yellow, Magenta.
D. Open the Black ink cartridge bag and take out the ink cartridge.
E. Carefully remove the sealing tape from the bottom of the ink cartridge.
You should peel the tape in the direction
away
from you.
Important
To prevent spilling ink and staining your hands and clothing, peel the
sealing tape gently and slowly. Do not touch the ink opening on the
cartridge or the removed tape.
The MFC starts printing the PRINT QUALITY
CHECK SHEET (only during initial ink cartridge
installation).
Check the sheet to see if the quality and
alignment are OK by following steps A and B.
Check Colour Block Quality and Alignment
Install the Ink Cartridges
8
STEP A: Colour Block Quality Check
The LCD shows:
1.YES 2.NO
IS STEP “A” OK?
Check the quality of the four colour blocks printed on the sheet.
(BLACK/CYAN/YELLOW/MAGENTA).
If the quality is OK for all colours, press
1
(YES) to go to
STEP B.
OR
If white horizontal lines appear in some colour blocks below,
press
2
(NO).
OK Poor
The LCD asks you if the print quality is OK for each colour.
1.YES 2.NO
BLACK OK?
Press
2
(NO) for any colour with a problem.
The LCD shows:
1.YES 2.NO
START CLEANING?
Press
1
(YES), then MFC starts cleaning the colours.
After cleaning is finished, press
Mono Fax Start. The
MFC starts printing PRINT QUALITY CHECK SHEET again
and goes back to the first step of STEP A.
STEP B: Alignment Check
The LCD shows:
1.YES 2.NO
IS STEP “B” OK?
Check the 600DPI and 1200DPI test print to see if No.5 most
closely matches the OK sample ( 0 ).
If No.5 is the best match, enter
1
(YES)OR
600 DPI
1200 DPI
}
}
Do NOT select
If another test print number is a better match for either 600DPI
or 1200DPI, enter
2
(NO) to select it.
For 600DPI, enter the number of the test print that most closely
matches the 0 sample (1-8).
SELECT BEST #
600DPI ADJUST
For 1200DPI, enter the number of the test print that most
closely matches the 0 sample (1-8).
SELECT BEST #
1200DPI ADJUST
The bottom of the white shipping cover is wet with ink that will cause stains, so wipe it clean before
you place it down.
Do not throw away the white shipping cover. You will need it for future transportation.
C. Push the four coloured ink cartridge covers one at a time so they pop up. Then remove the white
shipping cover by pulling it toward you and then lifting it up and out.
F. Each colour has its own correct position. Match the colours of the ink cartridge covers, First, gently
insert the Black ink cartridge, and then press the cover down until it clicks.
G. Repeat Steps D-F to install each colour ink cartridge.
H. After installing all ink cartridges, close the scanner cover until it clicks into place. Your MFC will enter a
head cleaning cycle for approximately four minutes.
Make sure the paper is loaded in the multi-purpose sheet feeder. The LCD shows CLEANING. After the
cleaning cycle is finished, the LCD shows PRESS FAX START.
I. Press Mono Fax Start and go to Step 8 Check Colour Block Quality and Alignment.
Page 2
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Brother MFC-590 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Brother MFC-590 in the language / languages: English as an attachment in your email.

The manual is 1,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Brother MFC-590

Brother MFC-590 User Manual - English - 164 pages

Brother MFC-590 Installation Guide - German - 6 pages

Brother MFC-590 User Manual - German - 189 pages

Brother MFC-590 Installation Guide - Dutch - 6 pages

Brother MFC-590 User Manual - Dutch - 168 pages

Brother MFC-590 Installation Guide - French - 6 pages

Brother MFC-590 User Manual - French - 173 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info