550925
7
Zoom out
Zoom in
Previous page
1/8
Next page
a
L

7 S =
L ~
 7 S =
/
 7 S =

7 S =
:
2 =

L
@
L
@
L
B
L
@
B
:
B
L ~

9
Insert for liquid detergent depending on model
Position insert for dosing liquid detergent:
Completely remove detergent drawer. aPage 10
Push insert forwards.
Do not use insert (push upwards):
For gel-like detergents and washing powders,
For programmes with 7 Prewash.
Care
ʑ
Machine housing, control panel
Remove detergent residue immediately.
Wipe with a soft, damp cloth.
Do not clean the appliance with a water jet.
Clean the detergent drawer ...
... if it contains detergent or fabric softener residue.
1. Pull out, depress insert, take out drawer all the way.
2. Take out insert: using your finger, press insert upwards.
3. Clean detergent dispenser and insert with water and a brush and dry.
4. Attach insert and lock into position (push cylinder onto guide pin).
5. Slide in the detergent dispenser.
Leave detergent drawer open so that residual water can evaporate.
ʑ
Drum
Leave washing machine door open so that the drum can dry out.
Use chlorine-free cleaning agent, not steel wool.
ʑ
Descaling No washing in the machine!
Not required if detergent dosed correctly. However, if this does occur, follow the instructions
of the descaling agent manufacturer. Suitable descalers can be purchased on our website
or from customer service.
Information about the indicator lights depending on model
A signal sounds and the indicator lamps for spin speed and status displays flash:
¤
¤
¤
¤
¤
¤
¤
¤
¤
Close the washing
machine door
properly;
washing may
be caught.
¤
¤
¤
¤
¤
¤
¤
¤
¤
Turn on tap fully, supply
hose kinked/jammed;
clean filter aPage 10,
water pressure too low.
¤
¤
¤
¤
¤
¤
¤
¤
¤
Drain pump blocked;
clean drain pump.
aPage 10
Drainage hose/outlet
pipe blocked; clean
drainage hose on the
siphon. aPage 10
¤
¤
¤
¤
¤
¤
¤
¤
¤
Water in the base
pan, appliance
leaking. Call
customer service!
¤
¤
¤
¤
¤
¤
¤
¤
¤
or
¤
¤
¤
¤
¤
¤
¤
¤
¤
or
¤
¤
¤
¤
¤
¤
¤
¤
¤
Motor fault. Call
customer service!
Other displays: Switch off appliance, wait 5 seconds and switch on again.
If the display is indicated again, call customer service. aInstallation Instructions
Risk of electric shock! Pull out the mains plug!
Risk of explosion! No solvents!
10
Maintenance
Detergent-solution pump
Set programme selector to Off, pull out the mains plug.
1. Take the drainage hose out of the holder.
Remove sealing cap, allow detergent solution to flow out.
Put the closing cap back on the hose.
2. Carefully unscrew the pump cover (residual water).
3. Clean the interior, pump cover thread and pump housing
(fan impeller in the detergent-solution pump must rotate).
4. Reinsert and screw on pump cover.
Handle is upright. Insert the drain hose into the holder.
To prevent unused detergent from flowing into the outlet during the next wash:
Pour 1 litre of water into dispenser II and start the > Drain programme.
Drainage hose on the siphon
Set programme selector to Off, pull out the mains plug.
1. Loosen hose clip, carefully remove drainage hose (residual water).
2. Clean drainage hose and siphon spigot.
3. Re-attach drainage hose and secure connection point with hose clip.
Filter in the water inlet hose
Risk of electric shock!
Do not immerse Aqua-Stop safety device in water (contains electric valve).
Release water pressure in the supply hose:
1. Turn off the tap!
2. Select any programme (except Spin/> Drain).
3. Select $ Start/Pause. Leave programme for approx. 40 seconds.
4. Turn the programme selector to Off. Pull out the mains plug!
Clean the filter:
5. Disconnect the hose from the water tap.
Clean filter with small brush.
and/or for standard and Aqua-Secure models:
Remove hose from the rear of the appliance.
Take out filter with pliers and clean.
6. Connect the hose and check for leaks.
Risk of scalding!
Allow detergent solution to cool down!
Turn off the tap!
ʑ
ʑ
$
a
ʑ
a
a
a
ʑ
$
ʑ
a
a
ʑ
ʑ
S a
a
ʑ
ʑ
ʑ
~
a
ʑ
L
ʑ
ʑ a
a
ʑ
a
ʑ
ʑ
ʑ
2
ʑ
$
$
a
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bosch WIS24141 - 8 Logixx at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bosch WIS24141 - 8 Logixx in the language / languages: English as an attachment in your email.

The manual is 3,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info