753386
4
Zoom out
Zoom in
Previous page
1/31
Next page
6 7
EN EN
BEFORE FIRST USE
1. Please ensure the ice maker is level and on a stable table or platform to avoid
malfunction.
2. The incline angle of the ice maker cabinet should not exceed 45°during transportati-
on or use. Do not turn the ice maker upside down. Doing so could cause the com-
pressor or refrigerating system to operate incorrectly. Please allow time for the uids
in the compressor to settle after the ice maker is moved or transported. Before using
the ice maker for the rst time, please wait for 2 hours after the unit has been leveled
and positioned in the proper place.
3. Unpack the appliance, then check and make sure that all the accessories including
ice basket and ice scoop etc. are complete. Please contact with the client service
department if some accessories are missed.
4. The appliance must be placed on a dry and level surface with sucient ventilation,
far from heat sources such as ovens, heaters and corrosive gases.Leave an about
8-inch clearance on all sides of the ice maker for proper ventilation.
5. Do not ll the water reservoir with hot water. This may damage the ice maker. It isDo
not use the appliance at a very cold environment (lower than 50C).
6. Clean the appliance by following the operation of “CLEANING AND MAINTENANCE”
before operate.
USING YOUR ICE MAKER
1. Ensure that the drain plug at the bottom of water reservoir is closed well.
2. Plug the ice maker into the wall outlet, the “ICE” indicator blinks.
Note: Please make the ice maker be rested for 30 minutes before plug if it has been
moved.
3. Open the top lid and remove the ice basket.
4. Fill the water reservoir with drinking water.
Note: Do not ll above the MAX water level mark.
5. Replace the ice basket and close the top lid.
6. Press the ON/OFF key and the “ICE” indicator lights solidly.
7. The ice-making cycle will last approximately 7-15 minutes, depending on the ambient
temperature and water temperature.
8. The ice-making cycle starts with water being pumped into the ice tray situated below
the evaporator. Over the next 7-15 minutes ice forms on the evaporator. Once this
has completed, the ice tray will tilt backwards and the remaining water in the ice tray
is drained back into the water reservoir. The ice cubes are then dropped from the
evaporator and pushed forward into the ice basket by the ice shovel. The ice tray will
automatically move back into position under the evaporator and start the next cycle.
9. The “ICE FULL” indicator will light up when the ice basket is full and the ice maker will
stop the ice-making cycle automatically. Gently remove the ice from the ice basket
with the ice scoop. About 5 seconds later, the ice maker will restart its ice making
function automatically.
10. The “ADD WATER” indicator will light up when the water reservoir is lack of water
and the ice-making cycle will stop automatically. At that time, remove the ice basket
and add water to the water reservoir, and then press ON/OFF key again to restart the
ice-making cycle.
11. When you have got your desired amount of ice, stop the ice making cycle by pressing
the ON/OFF key and unplug the unit from the wall outlet.
12. Open the top lid and transfer the ice to a freezer.
Note: The ice will last in the ice maker for up to a 18 hour period, depending on the
ambient temperature.
13. Allow the ice maker to reach room temperature.
14. Suggest replacing the water every a week. Please empty the water reservoir if the ice
maker is not used for a long time.
CLEANING AND MAINTENANCE
Check and make sure the drain plug must be closed well. Fill the water reservoir with
clean water, then hold and press the“ON/OFF” key for 10 seconds, the pump will start to
pump water and keep running for 15 minutes, and it will enter into standby condition after
running for 15 minutes, nally, open the drain plug and empty the water
To keep your ice tasting fresh and your ice maker looking great, we recommend cleaning
your ice maker once per week.
1. Stop the ice-making cycle by pressing the ON/OFF key, unplug the ice maker from the
wall outlet and allow it to warm up to room temperature.
2. If residual water is found in the ice tray, gently push the ice tray back so that all water
drains into the water reservoir.
3. Move the appliance forward to a position 75mm away from the working table and
open the drain plug to drain out excess water (see Fig.3, Fig.4 and Fig.5).
4. Remove the ice basket.
5. Clean the evaporator by following the operation as below: pour the clean water into
the ice maker and run it to make ice for three cycles, and then empty the ice and
water in the ice maker.
6. Clean the ice maker interior with a soft cloth soaked with warm water and vinegar,
then rinse with clean water and then drain all the water.
7. Replace the drain plug well in position. Wash the ice basket and ice scoop in warm
soapy water. Rinse and dry.
8. Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing
soap, if necessary.
Note: Do not use organic solvent, boiled water, detergent, strong acid and strong
alkali etc. for cleaning.
9. Please empty the water reservoir and dry it for storage if the ice maker is not used for
a long time.
1 2 3
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blumill EP1069-GS - Ice cube machine at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blumill EP1069-GS - Ice cube machine in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info