614192
4
Zoom out
Zoom in
Previous page
1/40
Next page
XLf 200 A
4
ENGLISH
Introduction
Please read these operating instructions before using the
equipment for the  rst time.
We provide a manufacturer's warranty for products bought
within the European Union. For devices purchased outside
the European Union, the warranty terms issued by our re-
spective responsible domestic agency are valid. The warranty
terms can be called up from www.blaupunkt.com.
Safety Notes
Please observe the following safety notes during the instal-
lation and connection.
Disconnect the negative pole of the battery! Observe the
safety notes of the vehicle manufacturer.
When you drill holes, ensure that you do not damage any
vehicle components.
If the positive and negative cable are extended, ensure
that the cross section is not less than 2.5 mm
2
.
An incorrect installation can result in malfunctions of the
electronic vehicle systems or your car sound system.
Installation and connection instructions
With respect to accident safety, the XLf 200 A must be se-
cured in a professional way.
When selecting the installation location, select a dry loca-
tion that offers sufficient air circulation for cooling the
ampli er.
The XLf 200 A must not be installed on rear shelves, rear seats
or other locations that are open to the front.
The installation location must be suitable to accept the
accompanying screws and provide a  rm support (see page
37 / Fig. 1).
The ampli er power cable must be  tted with a fuse no more
than 30 cm from the battery to protect the vehicle battery in
case of a short circuit between power ampli er and battery.
The fuse of the ampli er protects only the ampli er, not the
vehicle battery.
Connection (see page 38 / Fig. 2)
1 10 A fuse
2 Preampli er inputs
3 Power-on indicator (Protect/ Power)
4 Input sensitivity
5 Upper cut-o frequency
6 Phase position
7 Connector cable
8 Right loudspeaker input
9 Left loudspeaker input
: – Earth
; + Battery
Bei Anschluss eines Autoradios anderer Hersteller ist die
Eingangsemp ndlichkeit entsprechend den Herstelleran-
gaben anzupassen.
Hierzu noch einige wichtige Erläuterungen:
Durch Drehen des Reglers im Uhrzeigersinn erhöht sich
die Eingangsempfindlichkeit des Verstärkers und damit
auch die Lautstärke. Es handelt sich jedoch nicht um eine
Lautstärkeregelung; in der Endposition lässt sich keine
höhere Verstärkerleistung erzielen, auch wenn sich dies
zunächst so anhört. Das System steigert lediglich schneller
die Lautstärke, wenn die Lautstärkeregelung des Autoradios
aufgedreht wird.
CROSSOVER Frequenzregelung
Der CROSSOVER Regler 5 ermöglicht die Einstellung der
gewünschten Einstiegsfrequenz.
Beispiel:
Bei einer Einstellung von 150 Hz hat der Verstärker einen
Frequenzbereich von 20 Hz bis 150 Hz.
Einstellungen
Als Grundeinstellung vor der Inbetriebnahme empfehlen wir
folgende Reglerpositionen: Emp ndlichkeit (VOL) Pos. 4 auf
Minimum, PHASE Pos. 6 auf 0°, Filter (CROSSOVER) Pos. 5
auf ca. 80 Hz. Schalten Sie die Anlage ein und wählen Sie ein
Musikstück mit ausgeprägter Basswiedergabe.
Erhöhen Sie die Lautstärke an Ihrem Autoradio bis zum
gewünschten Lautstärkepegel. Drehen Sie nun den VOL
Regler
4 vorsichtig so weit auf, bis Sie eine deutliche
Verstärkung des Basspegels hören. Danach wählen Sie
mit dem CROSSOVER Regler 5 eine Filtereinstellung, die
einen gut konturierten Bass erreicht. Eventuell müssen Sie
die VOL Reglereinstellung 4 und die Filtereinstellung 5
wechselweise optimieren.
Dröhnender Bass mit übertriebenem Volumen erfordert eine
Filtereinstellung mit niedriger Frequenz.
Der Phasenregler
6 soll so eingestellt werden, dass sich der
Bass möglichst gut in das Klangbild integriert und nicht als
einzelne Quelle hörbar wird.
Überprüfen Sie Ihre Einstellungen auch mit voll aufge-
drehtem Bassregler und ggf. eingeschalteter Loudness. Eine
Übersteuerung der Subwooferbox durch zu hoch gewählte
Verstärkung (Pos.
4) führt zu verzerrter Wiedergabe und
kann den Lautsprecher zerstören.
Betriebsanzeige (PRT/PWR)
Grünes Licht:
Endstufe an, regulärer Betriebszustand.
Rotes Licht:
Endstufe ist elektronisch abgeschaltet, da Fehlerfall vor-
liegt.
Recycling und Entsorgung
Bitte nutzen Sie zur Entsorgung des Produktes die
zur Verfügung stehenden Rückgabe- und Sammel-
systeme.
Änderungen vorbehalten!
BM_XLf200A_22LG.indd.indd 4BM_XLf200A_22LG.indd.indd 4 12.09.2012 11:51:40 Uhr12.09.2012 11:51:40 Uhr
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Blaupunkt Blue Magic XLf 200 A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Blaupunkt Blue Magic XLf 200 A in the language / languages: All languages as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info