662959
4
Zoom out
Zoom in
Previous page
1/4
Next page
5019 400 00360
With this function, you can set the
programme to end at a later time: press the
button to select in how many hours time you
wish the programme to finish. This option
allows you to have your laundry ready at a
particular time and to benefit from more
favourable energy rates, for example, during
the night. Do not use liquid detergent when
using this function.
The time until the “Cycle end” can be
selected in complete one-hour time
intervals (1 to 24 hours). When you press
the button, the shortest possible time will
be displayed; press the button again to
run through all the available times. To
remove the time, keep pressing the
button until you see the value “0:00”.
When you have selected the desired time
until the “Cycle end”, press “Start/Pause”
to start the countdown.
During the countdown, you can still
modify the programme settings (select or
deselect options, change spin speed, etc.).
If the changes prolong the programme
duration so that it overruns the time until
the “Cycle end” that was originally set, the
programme will start immediately.
Sometimes the programme may finish
before the selected time until the “Cycle
end” has expired (e.g. with small loads).
In this case, the washing machine will
tumble the laundry regularly to keep it
fresh, until the selected “Cycle end” time is
reached. During tumbling, the display will
show an animation. The tumbling phase
can be stopped at any time either by
pressing any button or by turning the
programme selector; the animation will
stop and the door will unlock after about
1 minute, which will be indicated on the
display.
Using the “Dosing aid” recommendation, you
can see the recommended detergent
quantity for your wash load. The detergent
recommendation is based on the soiling level
set and the size of the wash load.
Helps to save detergent. Protects the
environment and sensitive skin by
avoiding detergent overdosing.
Before using this function, you must adapt
the washing machine to the dosing
amounts which are recommended for the
detergents you are using. Also check if
your region’s water hardness corresponds
to your washing machine’s “soft” water
hardness level - if not, change the water
hardness setting on your washing
machine.
Select the programme, options and cycle
end BEFORE using the “Dosing aid” button.
For more details, refer to the separate
instructions.
The “Eco monitor” gives you a rough
overview of the power consumption for the
programme you selected.
As soon as you turn the programme selector
to any programme, the “Eco monitor”
function is switched on.
The indicator on the left shows that the “Eco
monitor” function is on. The four indicators
next to it show the consumption: the less
energy your programme is expected to use,
the less indicators will light up. This depends
on the programme, temperature and options
selected, and also on the size of the wash
load. For this reason, the Eco monitor
indicator may still change once the wash load
has been detected.
SETTING CYCLE END DETERGENT DOSING
RECOMMENDATION
ECO MONITOR
less more
Before the start of a programme and after the
end of a programme, the indicator lights up to
show that the door can be opened. While a
wash programme is running, the door is
locked and must not be forced open under
any circumstances. If, however, you have an
urgent need to open it while a programme is
running, refer to “Reset a running
programme”.
Open the tap and press the “Start/Pause”
button. The “Start/Pause” indicator
lights up.
Activating the child lock prevents children
from starting a wash cycle and from being
able to adjust the settings. The child lock
cannot be activated or deactivated when the
programme selector is in the “Off/O”
position. To activate the child lock:
Turn the programme selector to a
programme position or start a programme
as usual.
Press and hold the 2 buttons marked with
the key symbol at the same time for
several seconds. A key-like symbol will
briefly flash on the display to indicate that
the child lock is active.
Any time you try to change a programme
setting while the child lock is active, the
display will briefly show the key-like symbol.
The programme setting can no longer be
changed. The only change possible is to
switch the washing machine off by turning
the programme selector to the “Off/O”
position. The process for disabling the child
lock is the same as for enabling it.
If one of the failure indicators lights up,
consult the “Troubleshooting Guide” in your
Instructions for Use.
Spin speed flashes on the display:
Imbalance during spinning.
The “Door open” indicator lights up and
the display shows “End”.
1. Turn the programme selector to the
“Off/O” position.
2. Close the water tap.
3. Open the door and unload the machine.
4. Leave the door ajar to allow the drum to
dry.
This symbol will light up at the end of the
programme if you have used too much
detergent. Use less detergent next time.
1. Press the “Start/Pause” button to
pause the programme. The indicator
flashes.
2. Select the new programme, temperature,
any options and, if necessary, another
spin speed.
3. Press the “Start/Pause” button again.
The new programme continues in the
same phase in which the previous
programme was interrupted. Do not add
detergent for this programme.
Pressing the “Reset/Drain” button
cancels a programme before the end.
Press and hold the “Reset/Drain
button for a few seconds; an animation
appears on the display. The water is
drained out; there may be a short delay
before you can open the door.
“DOOR OPEN” INDICATOR
PROGRAMME START
CHILD LOCK
FAILURE INDICATORS
PROGRAMME END
“DETERGENT OVERDOSAGE”
INDICATOR
CHANGING THE PROGRAMME
AND/OR OPTIONS AFTER
PROGRAMME START
RESETTING A RUNNING
PROGRAMME BEFORE
THE END
- the sensor technology adapts water and energy consumption as well as the programme duration based on the load quantity
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Bauknecht Super Eco 6413 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Bauknecht Super Eco 6413 in the language / languages: English as an attachment in your email.

The manual is 2,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Bauknecht Super Eco 6413

Bauknecht Super Eco 6413 Additional guide - English - 4 pages

Bauknecht Super Eco 6413 Additional guide - German - 4 pages

Bauknecht Super Eco 6413 User Manual - German - 4 pages

Bauknecht Super Eco 6413 Installation Guide - German, Dutch - 12 pages

Bauknecht Super Eco 6413 Additional guide - Dutch - 4 pages

Bauknecht Super Eco 6413 User Manual - Dutch - 4 pages

Bauknecht Super Eco 6413 Installation Guide - French, Italian - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info