168995
128
Zoom out
Zoom in
Previous page
1/134
Next page
125-EN
Disc playback sound skips due
to vibration.
Improper mounting of the unit.
- Securely re-mount the unit.
Disc is very dirty.
- Clean the disc.
Disc has scratches.
- Change the disc.
The pick-up lens is dirty.
- Do not use a commercial available
lens cleaner disc. Consult your nearest
ALPINE dealer.
Disc playback sound skips
without vibration.
Dirty or scratched disc.
- Clean the disc; damaged disc should
be replaced.
CD-R/CD-RW playback not
possible.
Close session (finalization) has not
been performed.
- Perform finalization and attempt
playback again.
Error displays
Mechanical error
- Press
. After the error indication
disappears, insert the disc again. If the
above-mentioned solution does not
solve the problem, consult your
nearest ALPINE dealer.
MP3 or WMA is not played back.
Writing error occurred. The CD format
is not compatible.
- Make sure the CD has been written in
a supported format. Refer to About
MP3/WMA on pages 122-123, then
rewrite in the format supported by this
device.
Unit does not operate.
Monitors power is not turned on.
- Turn on the monitors power.
Condensation.
- Wait a while (about 1 hour) for the
condensation to dry.
No picture is produced.
Monitors mode is not switched to the
mode you want to see.
- Switch to the mode you want to see.
Monitors parking brake cord is not
connected.
- Connect the monitors parking brake
cord and set the parking brake.
(For details, refer to the monitors
instructions.)
Monitors parking brake is not set.
- Connect the monitors parking brake
cord and set the parking brake.
(For details, refer to the monitors
instructions.)
Playback does not start.
Disc is loaded upside-down.
- Check the disc and load it with the
labeled side facing upward.
Disc is dirty.
- Clean the disc.
A disc not able to playback with this
unit is loaded.
- Check if the disc is able to be played
back.
Parental lock is set.
- Cancel the parental lock or change the
rating level.
Picture is unclear or noisy.
Disc is being fast-forwarded or fast-
reversed.
- The picture may be slightly disturbed,
but this is normal.
Vehicles battery power is weak.
- Check the battery power and wiring.
(The unit may malfunction if the
battery power is under 11 volts with a
load applied.)
Monitors fluorescent tube is worn.
- Replace the monitors fluorescent
tube.
Image stops sometimes.
Disc is scratched.
- Replaced with a non-scratched disc.
128


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Alpine dvi 9990 r at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Alpine dvi 9990 r in the language / languages: English as an attachment in your email.

The manual is 6,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Alpine dvi 9990 r

Alpine dvi 9990 r Installation Guide - English - 12 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info