663408

Zoofari ZTSD 36 A1 - IAN 87694 Manual

12
Zoom out
Zoom in
Previous page
1/14
Next page
- 9 -
Safety instructions
To avoid the risk of accidents and
injuries:
• This appliance is not intended for use by
individuals (including children) with restricted
physical, physiological or intellectual abilities or
defi ciences in experience and/or knowledge
unless they are supervised by a person respon-
sible for their safety or receive from this person
instruction in how the appliance is to be used.
• Children should be supervised to ensure that
they do not play with the appliance.
• Use only the original accessory parts for this
device.
• Check the cutting head for proper function
before using the appliance.
• Never use the appliance with a damaged or
broken trimming guide. The absence of teeth on
the trimming guide can lead to injury.
• Switch the appliance off before you put it down.
To avoid the risk of an electric shock:
• Connect the appliance only to correctly
installed and earthed mains sockets that are
easily accessible. Ensure that the rating of the
local power supply tallies completely with the
details given on the rating plate of the device.
• Ensure that the power cable does not become
damaged. Protect the power cable from sources
of heat and ensure that it cannot be damaged.
• To avoid risks, arrange for defective plugs and/
or cables to be replaced at once by qualifi ed
technicians or our Customer Service Department.
• Do not use the appliance in the close vicinity
of a bath/shower or a sink fi lled with water.
The proximity of moisture presents a danger,
even when the appliance is switched off .
• NEVER submerse the appliance in water or
other liquids.
• Should the appliance be dropped into water,
ABSOLUTELY disconnect the plug from the
mains socket before extracting the appliance.
• After use or when cleaning it, ALWAYS remove
the plug from the mains power socket. Do not
pull on the power cable directly, pull the plug.
• The appliance is suitable for use only in dry
areas.
• ATTENTION! Keep the appliance dry.
• Do not use the unit while the animal is being
bathed or when the fur is wet.
Operation
The fur to be cut must be dry and clean. Brush the
fur through to remove any knots.
•
Remove the blade guard from the cutting
head 1
.
• Place the required trimming guide (- )
with the prongs facing upwards on the cutting
head 1 and thereby press the fl ap of the trim-
ming guide down fi rmly onto the lower metal
edge of the cutting head (see illustration).
• Ensure that the trimming guide has properly
engaged and is secured before starting to cut/
trim the fur.
Note:
It is advisable to fi rst trim a small area so as to test
the individual comb attachments. Start with a comb
attachment for long hair (1/2“
or 3/8“
)
and, if necessary, use a shorter one. The comb
attachments permit cutting lengths from 3 to 13 mm.
•
Switch the appliance on by sliding the On/Off
switch 3 to the position „ON“.
• Slowly run the appliance through the fur against
the direction of hair growth. Hold the appliance
so that the trimming guide is as fl at as possible
against the animal.
•
In addition, with the adjustment switch
4
the cutting
length of the cutter head
1
can be adjusted in steps
(up to 2 mm) without having to exchange the comb
attachment. To do this, slide the adjustment switch
4
backwards to increase the cutting length in steps.
With this the cutting length of the respectively
attached comb attachment is also increased by
up to 2 mm.
Slide the adjustment switch
4
forward again to
reduce the cutting length or to bring the comb
attachment back into its original position.
•
Through removal of the individual trimming
guide, i.e. using only the cutting head
1
itself,
you can cut clean contours.
•
After use, switch the appliance off by sliding the
On/Off switch
3
to the position „OFF“.
IB_87694_ZTSD36A1_LB1.indd 9IB_87694_ZTSD36A1_LB1.indd 9 28.11.12 16:1128.11.12 16:11
… 12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zoofari ZTSD 36 A1 - IAN 87694 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zoofari ZTSD 36 A1 - IAN 87694 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 0,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info