637212
6
Zoom out
Zoom in
Previous page
1/7
Next page
6
10
11
12
COMMISSIONING
Make sure that the vehicle is located outside, and that the GPS reception is not adversely affected by any
shadowing (trees, high buildings etc.). Now insert the navigation software SD card (No. 2) supplied into the
microSD card slot of the ZENEC system, and start it in order to establish a sat fix. Make sure that the vehicle
is not moved until the sat fix is established. Now press the NAV button to start the navigation mode, and
choose map view. Once your present location can be seen in the map view the sat fix has been established.
This can take 3 to 5 minutes. You can now use the ZENEC system.
Finally carry out a general functional test and perform the basic and car specific settings (AC, OPS etc.).
Also ensure that no fault warnings appear on the vehicle side.
12. Press the trim frame back on to make the instal-
lation complete.
Make sure that all connectors at the rear of the ZENEC system have sufficient room and are not bent.
Connectors without a retaining mechanism must be additionally secured with insulating tape.
If the navigation arrows are not present in the multi-functional display MFA+, although the needed
data are available via the CAN bus system, you have to unlock them first. Please contact a qualified
specialist workshop in such a case. Inappropriate actions can cause damage to the vehicle and
the ZENEC system.
11. Neatly arrange the wires to the side, making
room for the ZENEC system. Carefully slide it
into the radio slot and fix it in place, using the
four original Torx screws.
10. Connect all the cables to the ZENEC system
(No. 1): those previously run in the radio slot,
and the original antenna cables.
NOTE
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zenec Z-E2026 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zenec Z-E2026 in the language / languages: English as an attachment in your email.

The manual is 3,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zenec Z-E2026

Zenec Z-E2026 Quick start guide - German - 16 pages

Zenec Z-E2026 Quick start guide - Dutch - 9 pages

Zenec Z-E2026 Quick start guide - Spanish - 9 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info