538924

Zelmer Doris 393 Manual

25
Zoom out
Zoom in
Previous page
1/26
Next page
27
393-119_v01
ham, ham sausage into slices about 2 mm thick, ●
hard cured meats, salami into slices about 1 mm ●
thick.
Usability of the device is mostly based on knife condition.
●
Avoid slicing hard products as it causes quick blunting
of the knife.
The slicer must not be used for slicing:
●
frozen food, meat with bones, ●
fruit with hard stones e.g. apricots, plums, etc., ●
products wrapped in foil or plastic wrap. ●
Cleaning and maintenance (Fig. D)
After nishing work turn the slicer off and disconnect the
●
connecting cord.
1
Set the regulator in a position corresponding to thickness
of slicing 0 mm. Such setting prevents from accidental
access to the knife.
After every use the slicer should be cleaned and dried.
●
Wipe the drive with damp cloth and washing-up liquid.
●
It
must not be immersed in water or washed in running
water.
After slicing cheese, cured meats and vegetables
●
especially wash the following elements:
Plastic parts wash in warm water and washing-up ●
liquid,
Metal parts wash in hot water and washing-up liquid. ●
Dry the washed parts carefully.
●
If the slicer should be thoroughly cleaned you must
●
rst disassemble the knife, carriage and regulator.
Disassembly is done in reverse order than the assembly.
To disassembly the carriage from the table you should:
2
lift the carriage from the table.
3
Dismantle the knife turning the handle right until
resistance and pull ‘it’ towards yourself.
After dismantling the knife you should remove the
●
leftovers with a brush.
Wash remnants of fat or other stains visible on the knife
●
using brush and running water holding the knife by the
handle.
Dry the knife carefully after washing.
●
Knife blades are
very sharp.
Install the clean knife into the body by putting it into
●
socket and turning knife handle left until noticeable
resistance.
4
Disassembly the regulator by removing slicer crank until
the regulator slides away from the body.
After cleaning the regulator install it to the slicer’s body.
●
Disassembly of the regulator is done in reverse order
than the assembly.
Ecology – environment protection
Each user can protect the natural environment. It is neither
difcult nor expensive.
In order to do it: put the cardboard packing into
recycling paper container; put the polyethylene
(PE) bags into container for plastic.
When worn out, dispose the appliance to
particular disposal centre, because of the
dangerous elements of this appliance, which
can be hazardous for natural environment.

The manufacturer does not accept any liability for any damages
resulting from unintended use or inappropriate handling.
The manufacturer reserves his rights for modifying the product any
time in order to adjust it to law regulations, norms, directives, or due
to construction, trade aesthetic or other reasons, without notifying it
in advance.
… 25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer Doris 393 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer Doris 393 in the language / languages: English, Polish as an attachment in your email.

The manual is 1,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info