539209
38
Zoom out
Zoom in
Previous page
1/38
Next page
40 AH1001-001_v01
4
Gently clean the ultrasonic transducer, using the brush
supplied.
Regular cleaning reduces scaling.
PREVENTION AGAINST SCALE BUILD
Use cooled boiled water or distilled water. The water
temperature should not exceed 40°C.
At least once a week clean the water tank, humidier
base and ultrasonic transducer.
Before using the humidier, always pour fresh water into
the water tank.
If you do not use the humidier for a long time, empty the
water tank and humidier base, then wash all parts of the
humidier, wipe and dry it.
The appliance is best stored in its original packaging.
DESCALING THE AIR HUMIDIFIER
1
Turn the appliance off by turning the control knob to
position and disconnect the plug from the wall outlet.
2
Fill the container with 50 ml of vinegar (6% solution of
acetic acid) and 100 ml of water, and mix the whole. Pour
the resulting solution into the base of the humidier for 30
minutes.
3
Empty the base of the humidier (see section “DRAINING
THE BASE OF HUMIDIFIER”) and remove the scale with
a soft cloth.
4
Rinse the base of humidier with clean water and dry it
with an absorbent cloth.
Be careful that no water gets into the fan outlet
(electrical components) because it may cause
serious damage to the humidier.
If water gets into the fan outlet, contact your
service center.
DRAINING THE BASE OF HUMIDIFIER
1
Turn the appliance off by turning the control knob to
position and disconnect the plug from the wall outlet.
2
Empty the base of the humidier removing the
accumulated water (as shown in the photo).
Pouring water out in the wrong way may result
in water entering the outlet of the fan and
consequently cause serious damage to the
humidier.
If water gets into the fan outlet, contact your
service center.
Cleaning and maintenance
The humidier should be cleaned at least once
a week.
1
Before cleaning, turn the appliance off by turning the
control knob to position and disconnect the plug from
the wall outlet.
2
Remove the water tank from the base of the humidier,
lifting it up. Turn the water tank upside down.
3
Loosen the cap with the valve by turning it counter
clockwise and drain the water remaining in the tank.
Fill water tank with hot water and mild detergent
(dishwashing liquid), tightly screw the cap with the
valve and shake the tank several times. Empty the tank.
Repeat the operation several times by pouring water
into the tank without detergent until complete removal of
detergent residue.
Pay attention not to leave any cleaning solution
(detergent) in the water tank.
Empty the base of the humidier removing the
accumulated water (see section “DRAINING THE BASE
OF HUMIDIFIER”).
C
E
Troubleshooting
Check the below listed comments and notices before requesting service.
PROBLEM POSSIBLE CAUSE REMEDY
The warning light does not work; there is no
haze and blowing.
The appliance is not plugged into a wall
outlet.
Plug the cord into an electrical outlet.
No power to the appliance. Check electric circuit – fuses.
The appliance is turned on, the indicator light
is illuminated, no haze and blowing.
The water level in the tank for water has
fallen below the required.
Fill the water tank.
Too low humidication level is set. Set a greater level of humidication.
Too much water in the base of humidier. Pour water from humidier base, and then
tighten the cap with the valve tightly on the
water tank.
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer AH1001 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer AH1001 in the language / languages: English, Polish as an attachment in your email.

The manual is 1,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info