539093

Zelmer 32Z011 Manual

26
Zoom out
Zoom in
Previous page
1/30
Next page
28
Important safety instructions
Read the whole instruction for use before you start using
●
your stand blender.
The stand blender is intended for domestic usage only.
●
In case it is used for gastronomic business purposes,
warranty terms and conditions change.
Connect the appliance to 230-240 V mains supply.
●
Always place the appliance on at, plain surface.
●
Always unplug the appliance when it is not in use and
●
before cleaning.
Do not unplug by pulling on cord.
●
The supplying cord shall not be hanged over the edge of
●
the table or board, nor touch any hot surface.
Do not operate the appliance if the cord, the housing or
●
the handle is visibly damaged. In such a case, return the
appliance to a service center.
If the non-detachable part of the cord is damaged,
it should be replaced by the producer or at a proper
service point or by a qualied person in order to avoid
any hazards.
The appliance should be repaired by trained staff only.
Improper repair can result in serious hazard for a user. In
case of defects we recommend you to contact qualied
service desk.
Do not immerse motor housing in water or any other
●
liquid; do not use it in bathroom and outdoors.
Do not use stand blender without feeder opening stopper.
●
Do not ll the jug in with boiling liquids.
●
Do not put your hands inside the jug, even if it is removed
●
for cleaning, as the cutting blades are still dangerous –
very sharp.
Do not put any objects (spoon, etc.) into the jug, when
●
the blender is connected to power supply.
Keep the stand blender and supplying cord away from
●
hot surfaces and burners.
If it is possible, store the stand blender away from direct
●
sun radiation and glow-like light.
Never store with lid closed on the blender jug. Damp the
●
lid gasket with water before usage, and insert the lid on
the jug.
Do not overow the jug. In case the liquid gets under
●
the motor housing, it can be vacuumed into the motor,
causing its damage.
Do not ll the jug over 1500 ml mark – in such case, the
●
content of the jug can lift the lid when the motor starts up
After 2 minutes operation stop the appliance for at least
●
minute to let the motor cool down. You can repeat this
cycle maximum10 times.
Do not operate when the jug is empty, as it can get
●
overheated.
Do not wash the cutting blades directly with hand.
●
Use the soft brush for washing metal parts, especially
●
the sharp blades.
This appliance is not intended for use by persons
●
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Children should be supervised to ensure that they do not
●
play with the appliance.
The temperature of mixed ingredients should not exceed
●
60°C.
Make sure you understand well above mentioned
instructions.
Technical specication
Technical parameters are indicated on the nameplate of the
product.
Admissible time of uninterrupted operation: 2 minutes.
Time of interval before next operation: 10 minutes.
Maximum noise level: 80 dB/A.
The stand blender is built in 2nd isolation class.
It does not require connection to the socket equipped with
grounding pin.
The stand blender meets the requirements of standards in
force.
The appliance meets the requirements of the directives:
Low Voltage Device (LVD) – 2006/95/EC. –
Electromagnetic compatibility (EMC) – 2004/108/EC. –
The product is marked with CE mark on the nameplate.
The outline of the appliance (Fig. A)
1
Lid overlay
2
Lid sieve
3
Blender jug
4
Speed control knob
5
Lid
6
Blade unit
7
Gasket
8
Motor unit
9
Anti-slip foot
Handling and operation (Fig. B)
Preparation for operation
Before rst operation of the stand blender (or operation after
longer storage time), clean the blender jug (3), lid (5) and
lid overlay (1) in warm water with dish washing liquid, rinse
them well and dry. Keep your hands far from the blades –
they are sharp.
Instructions for use
1
Place the motor unit (8) on the dry, rm, horizontal
surface near the power supply outlet and out of the reach of
children.
EN
… 26 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer 32Z011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer 32Z011 in the language / languages: English, Polish as an attachment in your email.

The manual is 1,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info