538920
62
Zoom out
Zoom in
Previous page
1/64
Next page
62
REMOTE CONTROLLER
12. Set on/off time indicator or current time.
13. Preset temperature indicator.
14. Cooling mode: COOL.
15. Dehumidifying mode: DRY.
16. Heating mode: HEAT- inactive in this model
17. Ventilation mode FAN.
18. Mode selection button. Each time you press the button the mode
will change in the following order: COOL, DRY, FAN.
19. TIMER button.
Used to set the time of the automatic switch on / switch off of the
appliance. When pressed together with the HOUR (27) button, al-
lows to set the time in the 1–12 hour range with an hourly break.
20. Keypad HOLD button.
21. FAN SPEED button. Changes the fan speed from HIGH, MED to
LOW.
22. SLEEP button – inactive in this model.
23. HOLD indicator.
24. TEMP button. Each time you press the button the temperature
will change by 1°C.
25. ON/OFF button.
26. MIN button. Used to set the current time in minutes.
27. HOUR button. Used to set the current time in hours and the auto-
matic switch on/switch off time in hours.
28. SWING button. Used to set the air delivery swing mode (left-right)
or the xed direction mode of air delivery.
29. LAMP button – inactive in this model.
30. CLEAN button – inactive in this model.
Technical specication of the remote controller
Rated voltage 3,0 V
Lowest voltage of CPU emitting signal 2,0 V
Signal receiving range 8 m
Setting the current time
Properly insert two AAA batteries in the battery compartment on the back of the remote controller (see picture).
After installing the batteries the remote controller will automatically set the time to: 0:00.
For instruction purposes, the time will be set to 10:15.
1. Press and hold the HOUR (27) for about 3 seconds. The time indicator will begin to ash.
2. Keep pressing the HOUR (27) button until 10 a.m. is set.
3. Press the MIN (26) button, the minute indicator will begin to ash. Keep pressing the button until it is set to 15.
4. Press the ON/OFF (25) button to conrm the set time. The set time will be automatically cancelled if the ON/OFF
(25) button is not pressed within 15 seconds.
AIR CONDITIONER FUNCTIONS
The air conditioner has three functions: COOL, DRY and FAN ventilation.
The temperature range for the cooling mode is from 17°C to 31°C, and for the dehumidifying mode is from 20°C to 31°C.
Power source
Plug the appliance only to a grounded AC socket connected to a protection circuit.
Do not connect the appliance to a multiple socket outlet which is also being used for other electrical appliances.
Insert the plug into a power source. After 2 seconds you will hear a beep. Press the ON/OFF (H) button on the control panel or the ON/
OFF (25) button on the remote controller for the appliance to start operating.
Cooling operation
1. Repeatedly press the MODE (D) button on the control panel or the MODE (18) button on the remote controller and choose the cooling
mode. The LCD display should show the COOL indicator. During the cooling operation always place the air inlet and hot air exhaust hose
outside the room e.g. through an open window.
2. Repeatedly press TEMP+ or TEMP- (C) button on the control panel or the TEMP (24) button on the remote controller to select the de-
sired room temperature at 17 – 31.
3. Press the FAN SPEED (B) button on the control panel or the FAN SPEED (21) button on the remote controller to select the desired fan
speed: HIGH, MED, or LOW.
4. Press the SWING (E) button on the control panel or the SWING (28) button on the remote controller to adjust the air delivery direction.
When the LCD display shows the symbol SWING ; the swing mode is set (left-right). Otherwise the xed direction mode of air delivery
will be set.
The upper and lower swinging ns (4) can be manually adjusted before the start of operation.
ATTENTION: In order to improve the cooling efciency follow the instructions below:
1. Draw the curtains if the room is directly exposed to the sun.
2. Do not place the air conditioner near other heat sources.
Dehumidifying operation
1. Keep the windows and doors closed for an effective dehumidifying operation.
2. Repeatedly press the MODE (D) button on the control panel or the MODE (18) button on the remote controller and choose the dehumidi-
fying mode. The LCD display will show the DRY indicator.
During the dehumidifying mode the fan speed cannot be adjusted. (The FAN SPEED button is inactive).
3. While using the dehumidifying mode the air conditioner can operate without the air outlet hose.
Open
the back cover
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer 23Z011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer 23Z011 in the language / languages: English, Polish as an attachment in your email.

The manual is 1,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info