24611
24
Zoom out
Zoom in
Previous page
1/28
Next page
24
Unpacking
The transport safeguard must be removed before
putting the appliance into operation.
Important !
You are advised to keep all the packaging for re-use in
case the machine is to be transported again.
After removing all the packaging, with assistance
carefully lay machine on it’s back to remove the
polystyrene base from the bottom.
Remove the power supply cable and the draining hose
from the hose holders on the rear of the appliance.
With a suitable spanner unscrew and remove the
central rear bolt A. Slide out the relevant plastic
spacer.
Unscrew and remove the two large rear bolts B and
the six smaller bolts C.
Remove the bracket D and tighten up the six smaller
bolts C.
Open the porthole and remove the polystyrene block
fitted with the adhesive tape on the door seal.
HEC0010
HEC0011
C
C
B
D
HEC0003
B
HEC0002
A
HEC0001
HEC0008
Fill the smaller upper hole and the two large ones with
the corresponding plastic plug caps supplied in the
bag containing the instruction booklet.
Important!
All the different plug caps are supplied with the
appliance in the plastic bag containing the instruction
booklet.
Connect the water inlet hose as described under the
paragraph “Water inlet”.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not
impeded by carpets, rugs etc. Check that the machine does
not touch the wall or other kitchen units.
Never place cardboard, wood or similar materials under the
machine to compensate for any unevenness in the floor.
Your new washing machine has been designed to be
permanently plumbed in to your home’s water supply
and drainage system. However, if this is not possible, it
may be connected to a suitable existing tap with the
drain hose discharging into a sink.
The appliance has an inlet hose, with female 3/4” BSP
thread connector. If this connection is not compatible with
the plumbing of the existing installation, a variety of
connectors are available from good hardware stores and
plumbers merchants to suit most domestic plumbing. Any
alteration to your existing plumbing must be carried out by
a competent person, or qualified plumber.
Installation on a Suspended Floor
Suspended wooden floors are particularly susceptible to
vibration. To help prevent vibration we recommend you
place a waterproof wood panel, at least 15 mm thick
under the appliance, secured to at least 2 floor beams
with screws. If possible install the appliance in one of
the corners of the room, where the floor is more stable.
HEC0009
HEC0005
132981530.qxd 20/06/2006 9.09 Pagina 24
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi ZWF1311W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi ZWF1311W in the language / languages: English as an attachment in your email.

The manual is 0,65 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info