345069
3
Zoom out
Zoom in
Previous page
1/22
Next page
3
¥ WŠhrend des Transports kann es vorkommen,
da§ das im Motorkompressor enthaltene …l in
den KŠltekreislauf ablŠuft. Man sollte mindestens
2 Std. warten, bevor das GerŠt in Betrieb
genommen wird, damit das …l in den
Kompressor zurŸckstršmen kann.
Gebrauch
¥ Die HaushaltskŸhl- und GefriergerŠte sind nur
zur Einlagerung bzw. zum Einfrieren von
Nahrungsmitteln bestimmt.
¥ Die beste Leistung erzielt man bei
Raumtemperaturen von +18¡C bis +43¡C (Klasse
T); +18¡C bis +38¡C (Klasse ST); +16¡C bis
+32¡C (Klasse N); +10¡C bis +32¡C (Klasse SN);
die GerŠteklasse ist auf dem Typschild
angegeben.
Zu beachten: Wird dieses GerŠtes bei anderen
Umgebungstemperaturen betrieben als den in
der entsprechenden Klimaklasse angegebenen
Werten, sind folgende Hinweise zu beachten:
sinkt die Umgebungstemperatur unter den
angegebenen Mindestwert ab, kšnnte die
Lagertemperatur im Gefrierabteil nicht mehr
garantiert sein; es wird daher empfohlen, die
eingelagerten Lebensmittel so rasch als mšglich
zu verbrauchen.
¥ Einaufgetautes Produkt darf nicht wieder
eingefroren werden.
¥ FŸr das Aufbewahren bzw. das Einfrieren der
Lebensmittel sind die Anweisungen des
Herstellers zu befolgen.
¥ In allen KŸhl- und GefriergerŠten bedecken sich
im Laufe der Zeit alle kŠltefŸhrenden Teile mit
einer Reif bzw. Eissicht. Diese Schicht wird je
nach Modell automatisch oder mit der Hand
abgetaut.
¥ Die Reifsicht niemals mit MetallgegenstŠnden
abkratzen, das GerŠt kšnnte beschŠdigt werden.
Dazu nur den mitgelieferten Plastikschaber
verwenden.
¥ Zum Lšsen der festgefrorenen Eisschalen keine
scharfkantigen oder spitzn GegenstŠnde
benutzen.
¥ Es sollten keine kohlensŠurehaltigen GetrŠnke in
das Gefrier- bzw. Frosterfach eingestellt werden,
sie kšnnten platzen.
Umweltnormen
Dieses GerŠt enthŠlt im KŸhlkreislauf und in der
Isolierung kein ozonschŠdigendes Gas. Das
GerŠt darf nicht mit dem HausmŸll entsorgt
werden. Eine BeschŠdigung des
KŠltemittelkreislaufs, insbesondere des
WŠrmetauschers auf der RŸckseite des GerŠtes,
mu§ verhindert werden. Auskunft Ÿber
Abholtermine oder SammelplŠtze gibt die
šrtliche Gemeindeverwaltung an. Die in diesem
GerŠt verwendeten und mit dem Symbol
gekennzeichneten Materialien,sind
recyclingfŠhig.
2222 041-53
42
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with current regulations, consulting a
specialist technician.
The Manufacturer declines all responsibility if
the above safety precautions are not observed.
This appliance complies with the following
E.E.C. Directives:
- 87/308 EEC of 2/6/87 relative to radio interference
suppression.
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic
Compatibility Directive) and subsequent
modifications.
INSTALLATION
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc.
For safety reasons, minimum ventilation must be as
shown in Fig.
Appliance positioned under overhanging kitchen wall
units (see Fig. A).
Appliance positioned without overhanging kitchen
wall units (see Fig. B).
Attention: keep ventilation openings clear of
obstruction.
Two adjustable feet at the cabinet base allow
accurate levelling of the appliance.
NP002
100 mm10 mm
10 mm
A
B
ATTENTION!
It must be possible to disconnect the appliance from
the mains power supply; the plug must therefore be
easily accessible after installation.
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the figure.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screws.
PR153
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanussi-electrolux zk 19 9 r 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanussi-electrolux zk 19 9 r 2 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,42 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info