528942

Zanker WTF968A.8 Manual

28
Zoom out
Zoom in
Previous page
1/32
Next page
• After positioning the inlet hose, be sure to tighten
the ring nuts again to prevent leaks.
• The inlet hose must not be lengthened. If it is too
short and you do not wish to move the tap, you will
have to purchase a new, longer hose specially de-
signed for this type of use.
Water-stop device
A
The inlet hose is provided with a water stop device,
which protects against damage caused by water
leaks in the hose which could develop due to natural
ageing of the hose. This fault is shown by a red sec-
tor in the window «A». Should this occur, turn the wa-
ter tap off and refer to your Service Centre to replace
the hose.
Water drainage
• The height of drain hose do not have to ex-
ceed 100 cm.
• The drain hose may be extended to a maxi-
mum of 4 metres. An additional drain hose and
joining piece is available from your local Serv-
ice Centre.
• The drain hose must not be kinked and must
be fastened to prevent it falls down.
The end of the drain hose can be positioned in three
ways:
max 100 cm
Directly into a drain
pipe.
Attach the hook to drain
hose and hang it in the
drain pipe. Make sure
that the drain hose
doesn't fall down.
The end of the drain hose must always be ventilated,
i.e. the inside diameter of the drain pipe must be larg-
er than the outside diameter of the drain hose.
Hooked over the edge
of a sink using the plas-
tic hose guide supplied
with the machine.
In this case, make sure the end cannot come un-
hooked when the machine is emptying. This could be
done by tying it to the tap with a piece of string or at-
taching it to the wall.
You can connect the
drain hose to a siphon.
The drain hose must be above the siphon.
Fix the drain hose to the siphon with a clamp.
The drain hose may be extended to a maximum
of 4 metres. An additional drain hose and join-
ing piece is available from your local Service Centre.
28
… 28 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanker WTF968A.8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanker WTF968A.8 in the language / languages: English as an attachment in your email.

The manual is 3,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Zanker WTF968A.8

Zanker WTF968A.8 User Manual - German - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info