337542
11
Zoom out
Zoom in
Previous page
1/12
Next page
11
H
G
Het wijzigen van de deurdraairicht-
ing
Neem vóór het wijzigen van de deurdraairichting
de stekker uit het stopcontact.
Ga nu verder als volgt te werk:
1. Ventilatierooster (D) verwijderen;
2. Verwijder het onderste scharnier (E).
3. Onderdeur verwijderen van het tussenscharnier
(H).
4. Verwijder het tussenscharnier (H).
5. Bovendeur van bovenscharnierpen (G) trekken.
6. Bovenste scharnierpen verwijderen en aan de
tegenovergestelde kant weer monteren, na de
dopjes verwijderd te hebben. Monteer de dopjes
nu aan de andere kant.
7. Bovendeur herplaatsen.
8. Tussenscharnier op de andere kant aanbrengen.
9. Onderdeur herplaatsen.
10.Plaats het onderste scharnier (E) weer aan de
andere kant.
11.Neem het kapje (F) uit het ventilatierooster (D)
door het in de richting van de pijl te duwen en
breng dit aan de andere kant aan.
12.Onderdeur herplaatsen.
13.Ventilatierooster (D) weer terugplaatsen.
14.De handgreep losschroeven en aan de andere
kant van de deur bevestigen nadat u de dopjes
met een priem doorgeprikt heeft. De vrijgekomen
gaatjes afsluiten met de bijgeleverde dopjes;
deze vindt u in het zakje van de documentatie.
Belangrijk:
Controleer na de richting van de deuren gewijzigd te
hebben, of alle schroeven goed vastgedraaid zitten
en of het deurrubber goed op de sponning sluit. In
een koud vertrek (in de winter) kan het gebeuren
dat dat niet het geval is. Na enkele dagen zal het
rubber zich echter aangepast hebben. Wilt u dat
bespoedigen, dan kunt u het rubber warm maken
met een föhn.
F
F
D
F
F
E
E
14
CONTENTS
Warnings .................................................................................................................................................13
Use - Cleaning the interior - Control panel - Operation - Temperature regulation - Ambient switch - .......
Fresh food refrigeration .............................................................................................................................15
Use - Freezing fresh food - Storage of frozen food- Freezing fresh food - Storage of frozen food - ..........
Ice-cube production - Thawing - Cold accumulators - Shelf holders - Movable shelves...............................
Positioning the door shelves .....................................................................................................................16
Hints - Hints for refrigeration - Hints for freezing - Hints for storage of frozen food .................................17
Maintenance - Periodic cleaning - Periods of no operation - Interior light ...............................................18
Maintenance- Defrosting - Customer service and spare parts ...........................................................19
Installation - Location - Rear spacers - Electrical connection .................................................................20
Installation - Door reversibility..................................................................................................................21
scrape off frost or ice. Frost may be removed by
using the scraper provided. Under no circum-
stances should solid ice be forced off the liner.
Solid ice should be allowed to thaw when
defrosting the appliance. See defrost instruc-
tions.
Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container,
which may cause it to explode, resulting in dam-
age to the appliance. Do not use a mechanical
device or any artificial means to speed up the
thawing process other than those recommended
by the manufacturer. Never use metal objects for
cleaning your appliance as it may get damaged.
Installation
During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum venti-
lation must be as shown in the relevant Figure.
Attention: keep ventilation openings clear of
obstruction.
There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
Parts which heat up should not be exposed.
Wherever possible the back of the product
should be against a wall.
If the appliance has been transported horizontal-
ly, it is possible that the oil contained in the com-
pressor flows in the refrigerant circuit. It is advis-
able to wait at least two hours before connecting
the appliance to allow the oil to flow back in the
compressor.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local dis-
posal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol are recicable.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanker usd 270 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanker usd 270 in the language / languages: English, Dutch as an attachment in your email.

The manual is 0,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info