341156
10
Zoom out
Zoom in
Previous page
1/12
Next page
10
Elektrische aansluiting
Overtuig u ervan dat de netspanning en de
netfrequentie, welke op het typeplaatje in de kast
staan aangegeven, overeenkomen met de netspan-
ning en de netfrequentie in uw woning. Een afwijking
op de netspanning tot plus of minus 6% is
toegestaan. Bij aansluiting op een andere spanning
dient u een geschikte transformator te gebruiken.
De steker mag alleen geplaatst worden in een
geaard stopcontact.
De kast is daarom voorzien van een speciaal drie-
aderig snoer, geschikt voor een geaard stopcontact.
Mocht het stopcontact in uw woning niet geaard zijn,
dan dient een erkend installateur het apparaat
volgens de geldende normen te aarden.
Wij wijzen u er op dat schade of letsel,
veroorzaakt door het niet voldoen aan dit
veiligheidsvoorschrift, niet onder de
verantwoordelijkheid van de fabrikant valt.
INSTALLATIE
Plaats van opstelling
Plaats het apparaat uit de buurt van
warmtebronnen: centrale verwarming, kachels, felle
zonnestralen enz.
Om veilingheidsredenen moet de ventilatie zodanig
zijn als aangegeven in Fig.
Plaatsing van het apparaat onder keukenhangkastjes
(zie Fig. A)
Plaatsing van het apparaat zonder keukenhangkastjes
(zie Fig. B)
Attentie: zorg ervoor dat de ventilatie openingen
tijdens gebruik niet worden afgedekt.
Teneinde oneffenheden in de vloer op te heffen is de
kast voorzien van één of meer verstellbare voetjes.
Dit apparaat voldoet aan de volgende EG-
richtlijnen:
- 87/308 EG-richtlijnvan 2.6.87 met betrekking tot
de radio-ontstoring.
- 73/23 EG-richtlijn van 19/02/73 (Laagspanning)
en opeenvolgende wijzingen;
- 89/336 EG-richtlijn van 03/05/89 (Elektromagne-
tische compatibiliteit) en opeenvolgende
wijzingen.
NP002
100 mm10 mm
10 mm
A
B
Muur-afstandshouders
In het documentenzakje bevinden zich twee
afstandhouders die in de bovenste hoeken aan
de achterzijde geplaatst dienen te worden.
Draai de schroeven los, steek de afstandhouder
onder de schroefkop en draai de schroeven weer
vast.
PR153
15
CONTENTS
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .14
Use / Cleaning the interior - Operation - Temperature regulation - Fresh food refrigeration - Freezing . .
fresh food - Storage of frozen food - Thawing - Ice-cube production . . . . . . . . . . . . . . . . . . . . . . . . . . . .16
Use / Cold accumulators - Ambient switch - Movable shelves - Positioning the door shelves . . . . . . . . .17
Hints / Hints for refrigeration - Hints for freezing - Hints for storage of frozen food - Maintenance . . . .
Periodic cleaning - Periods of no operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .18
Maintenance / Interior light - Defrosting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .19
Customer service and spare parts / Installation - Location - Rear spacers - Electrical connection . .20
Installation / Changing the opening direction of the doors . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .21
should solid ice be forced off the liner. Solid ice
should be allowed to thaw when defrosting the
appliance. See defrost instructions.
Do not place carbonated or fizzy drinks in the
freezer as it creates pressure on the container,
which may cause it to explode, resulting in
damage to the appliance. Do not use a
mechanical device or any artificial means to
speed up the thawing process other than those
recommended by the manufacturer. Never use
metal objects for cleaning your appliance as it
may get damaged.
Installation
During normal operation, the condenser and
compressor at the back of the appliance heat up
considerably. For safety reasons, minimum
ventilation must be as shown in the relevant
Figure.
Attention: keep ventilation openings clear of
obstruction.
There are working parts in this product which
heat up. Always ensure that there is adequate
ventilation as a failure to do this will result in
component failure and possible food loss. See
installation instructions.
Parts which heat up should not be exposed.
Wherever possible the back of the product
should be against a wall.
If the appliance has been transported
horizontally, it is possible that the oil contained in
the compressor flows in the refrigerant circuit. It
is advisable to wait at least two hours before
connecting the appliance to allow the oil to flow
back in the compressor.
Environment Protection
This appliance does not contain gasses which
could damage the ozone layer, in either its
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. Avoid damaging
the cooling unit, especially at the rear near the
heat exchanger. Information on your local
disposal sites may be obtained from municipal
authorities. The materials used on this appliance
marked by the symbol are recicable.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zanker usd 263 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zanker usd 263 in the language / languages: Dutch as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info