633004
27
Zoom out
Zoom in
Previous page
1/29
Next page
DISCLAIMER
Yuneec Electric Aviation cannot be held liable for any damage, injury or for use of the product
in violation with legal regulations, especially in the following circumstances:
Damage and/or injury as well violation of legal regulations resulting from a failure to comply
with the operating instructions or the instructions at www.yuneec.com, product information,
user manual and other legally binding information.
Damage and/or injury as well violation of legal regulations brought about by the influence of
alcohol, drugs, medication or other narcotics which may impact on the concentration of the user.
The same applies to illnesses effecting the concentration of the user (dizziness, tiredness,
nausea etc.) or other factors compromising mental and physical capabilities.
Intentionally caused damage, injury or violation of legal regulations.
Any request for compensation caused by an accident resulting from use of the product.
Damage and/or injury as well as violation of legal regulations caused by use of the product in
a no-fly zone, e.g. next to an airfield, above a motorway or a natural conservation area.
Malfunction of the product caused by retrofitting or replacement with components which did
not come from YuneecElectric Aviation.
Damage and/or injury caused by the use of replica parts (non-original parts).
Damage and/or injury as well as violation of legal regulations caused by incorrect operation
or misjudgement.
Damage and/or injury caused by damaged spare parts or not using original Yuneec Electric
Aviation spare parts.
Damage and/or injury as well as violation of legal regulations caused by ignoring the low
voltage battery warning.
Damage and/or injury caused by knowingly and negligibly flying with a damaged model or
one which is unfit to fly, e.g. due to dirt, water penetration, coarse particles, oil or a model
which has not been correctly or completely assembled or if the main components exhibit
visible damage, defects or missing parts.
Damage and/or injury as well as violation of legal regulations caused by operating the model
in a magnetic field (e.g. high voltage lines, electricity/transformer stations, radio towers,
mobile phone masts etc.), a strong wireless signal environment,no-fly zones, poor visibility
and in the event of vision impairments or other impacts on the pilot which are left unchecked etc...
Damage and/or injury brought about through a violation of the legal regulations for operat-
ing the model, in unsuitable weather conditions, e.g. rain, wind, snow, hail, storms, hurricanes etc.
Damage and/or injury as well as violation of legal regulations caused by force majeure, e.g.
collision, fire, explosion,flooding, tsunami, landslide, avalanche, earthquake or other forces of
nature.
Damage and/or injury as well as violation of legal regulations caused by the illegal or immoral
use of the model, e.g. capturing videos or recording data which infringes upon/harms the
privacy of other people.
Damage and/or injury as well as violation of legal regulations caused by incorrect use of the
batteries, protection systems, chargers or aircraft.
Consequential damage caused by the incorrect operation of any kind of system components
and accessory parts, especially memory cards, whereby image or video material from the
camera can become defect.
Any non-compliance with legal obligations, personal injury, material damage and environ-
mental damage caused by use and a failure to comply with the local laws and regulations.
Damage and/or injury as well as violation of legal regulations caused by hazardous use
without sufficient practical experience.
Damage and/or injury as well as violation of legal regulations caused by flying in legally
defined no-fly zones.
Further losses which do not fall within the scope of use defined by Yuneec Electric Aviation
as improper.
This product is designed for both professional use and personal, private use. The national and
international laws and regulations in force as the time of taking off must be adhered to.
FCC STATEMENT:
This equipment has been tested and found to comply with the limits for Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interfer-
ence in a residential installation. This equipment generates , uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encour-
aged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
RF EXPOSURE WARNING
• This equipment must be installed and operated in accordance with provided instructions
and the antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all persons and must not be co-located or operating in conjunction with
any other antenna or transmitter. End-users and installers must be provide with antenna
installation instructions and transmitter operating conditions for satisfying RF exposure
compliance.
IC RADIATION EXPOSURE STATEMENT FOR CANADA
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interfer-
ence, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouil-
lage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncon-
trolled environment.
25
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yuneec Tornado CGO4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yuneec Tornado CGO4 in the language / languages: English as an attachment in your email.

The manual is 1,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yuneec Tornado CGO4

Yuneec Tornado CGO4 Quick start guide - English - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info