638626
29
Zoom out
Zoom in
Previous page
1/33
Next page
PYROGAS VARINO 65 - 300
We reserve the right to make changes to dimensions and construction 27 Edition 02.09.2015
© Copyright YGNIS AG CH-Ruswil
Status display: Alternating display "noO2" standard display
Meaning: Failure of the O
2
control.
Possible cause: O
2
sensor defective
- The condensing unit continues to run in emergency mode for max. 72 hours.
After this time has expired, the unit shuts down.
- The safety block can only be released after the cause has been eliminated.
Further procedure: Inform the customer service and indicate the error code as well.
9.9.2. Display flashes
Unit is cold, condensing unit is not operating, information on the display flashes.
Status display: First figure = E
Figure 3 + 4 = Error code
Meaning: Determine error code by means of Annex 1: Error codes.
Further procedure: Note error code
Remedy cause and acknowledge with "RESET" key
Note: The starting sequence up to the ignition of the flame lasts at least 5 minutes
after the RESET key is pressed.
If the PYROGAS VARINO condensing unit should return to error after the
acknowledgement, then please contact the customer service.
9.9.3. Error codes
See Annex 1: Error codes, page 29.
9.10. Closing down the condensing unit after the heating season (summer operation)
- Burner switch on control panel to OFF. The figure A appears with the current boiler temperature on the status
display.
Units that have an installed Ygnis heating controller automatically switch to summer operation.
- Close gas shut-off cock on the boiler rear wall or in the gas supply line.
Note: The mains voltage should not be switched off by means of an external main switch because the
oxygen sensor must also be heated during the summer (power consumption approx. 1 watt).
If sanitary water production takes place in summer operation with the PYROGAS VARINO, the
burner switch may not be switched off.
In the case of frost danger when the unit is switched off, the installation must be emptied.
9.11. Commissioning the boiler when starting heating
- Open the gas shut-off valve on the boiler rear wall or in the gas supply line.
- Burner switch on control panel to ON. After a long stand-still it is possible that the burner will have a false
start (error message E 2) upon the initial start test. Use the "RESET" key to reset the unit. If a false start
occurs again, please notify your customer service.
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ygnis Varino at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ygnis Varino in the language / languages: English as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ygnis Varino

Ygnis Varino Usermanual and installation guide - German - 30 pages

Ygnis Varino Usermanual and installation guide - Dutch - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info