514325
228
Zoom out
Zoom in
Previous page
1/232
Next page
7-19
LIGHTING SYSTEM
CHECKING THE TAILLIGHT
(LEDs)
1. Disconnect the taillight coupler.
2. Connect two jumper leads "1"
from the battery terminals to the
respective coupler terminal as
shown.
3. Check:
LED (for proper operation)
Does not light Replace the tail-
light assembly.
A wire that is used as a jumper
lead must have at least the same
capacity of the battery lead, oth-
erwise the jumper lead may burn.
This check is likely to produce
sparks, therefore, make sure no
flammable gas or fluid is in the
vicinity.
CHECKING THE AC MAGNETO
1. Inspect:
Lighting coil resistance
Out of specification Replace.
CHECKING THE RECTIFIER/
REGULATOR
1. Connect the battery leads.
2. Start the engine.
3. Turn on the headlight and taillight
by turning on the light switch.
4. Inspect:
Out-put voltage
Out of specification Replace
rectifier/regulator.
Battery (+) terminal Blue lead
"2"
Battery (-) terminal Black lead
"3"
Tester (+) lead Yellow lead "1"
Tester (-) lead Ground "2"
Lighting
coil resis-
tance
Tester se-
lector posi-
tion
0.224–0.336
Ω at 20 °C
(68 °F)
Ω × 1
Tester (+) lead Yellow lead "1"
Tester (-) lead Black lead "2"
Out-put
voltage
Tester se-
lector posi-
tion
12.5–13.5 V
at 5,000 r/
min
ACV-20
228


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha WR 250 - 2013 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha WR 250 - 2013 in the language / languages: English as an attachment in your email.

The manual is 14,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Yamaha WR 250 - 2013

Yamaha WR 250 - 2013 User Manual - German - 238 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info