674740
61
Zoom out
Zoom in
Previous page
1/154
Next page
Page 59
FT-991 OperaTing Manual
1. Press the
BAND
button to show the band list, and
then touch a band key corresponding to the Amateur
band on which you wish to operate. Press the
BAND
button again, to close the band list screen.
2. Press the
MODE
button to show the mode list, and
then select the operating mode by touching the cor-
responding key. Press the
MODE
button again, to
close the mode list screen.
Advice:
By convention, LSB is used in the 7 MHz and lower
Amateur bands for SSB communication, and USB is
used on the 14 MHz and higher bands (the 10 MHz
band is used for CW and data modes only).
3. Rotate the Main Tuning Dial knob to adjust the op-
erating frequency. Alternately, you may use the
UP
/
DWN
scanning buttons on the
MH-31
A8J
Hand Mi-
crophone to scan up or down the current band.
4. Press the microphone
PTT
(Push To Talk) switch to
begin transmitting; speak into the microphone in a
normal voice level.
Advice:
The “
” indicator will light up in the TFT LED
indicators area, conrming that transmission is in
progress.
When transmitting in the AM mode, set a maxi-
mum (carrier) power output of 25 Watts by press-
ing
[
RF PWR
]
, then rotate the
MULTI
knob.
5. Adjust the microphone amplier gain to match the
microphone and your voice level: Touch
[
METER
]
on the LCD repeatedly to select the “
ALC
”.
Press and hold the
PTT
switch, and speak into the
microphone in a normal voice level.
In the SSB mode, touch
[
MIC GAIN
]
and then ad-
just
MULTI
knob so that the ALC meter stays within
the ALC zone of the meter (up to half scale deec-
tion) on voice peaks.
ssb/aM MoDe transMission
ON/OFF Switch
Main Tuning Dial Knob
F(M-LIST) Button
MULTI KnobMODE Button
BAND Button
In the AM mode, touch
[
MIC GAIN
]
and then adjust
the
MULTI
knob so that the ALC meter does not de-
ect on voice peaks.
When transmitting In the AM mode, adjust the
MIC gain so that the PO meter does not deect
when speaking.
6. Release the
PTT
switch at the end of the transmis-
sion. The transceiver will return to the receive mode.
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu FT-991 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu FT-991 in the language / languages: English as an attachment in your email.

The manual is 30,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info