730149
1
Zoom out
Zoom in
Previous page
1/2
Next page
Mi Power Strip
Specications
Features of device
Read the instruction before use the device
Name: Mi power strip (3 USB ports, 2А quick
charge)
Model: XMCXB01QM
Standard: Q/DXQMK0001-2015
Case material: high-quality thermo-resistant plactic;
Dimensions: 225х41х26 (mm)
Lenght: common lenght unclude cable: 1.8m
Weight: 300g (incl. cabel)
Input: 10А, 250V~
Output: 10А, 250V (электрическая розетка)
Power: 2500W
Input USB: 100-240V~, 50-60Hz, 0.5A
Output USB: 1 port USB, 5V-----2.1A(TYP), 3 ports,
5V-----3.1A(TYP)
Temperature range: -10С~+40C
Safety: Overload protection: at a time when the
current exceeds the limit, the device is automatically
disconnected from the power supply, thus preventing
an overload. After eliminating an emergency of
overload, you can manually resume the power strip,
by replacing a fuse.
Double protection: double, triple independent lines
of protection.
Heat resistance: high re-resistant material,
which complians to international standards, which
slows down the spread of re or even prevent the
possibility of re.
High performance: 3 USB ports for simultaneous
charging of three devices. Compliance to
international standards, each slot can be used for
the same standard outlets with three at prongs, two
plugs and sockets for standard German with two
round 4.8mm plugs. Stainless steel, new technology,
low rate of increasing temperature of device.
Options: integrated automatic chip, which have an
ability to quickly recharge the 5V for most devices
such as the Mi device, Apple, Samsung and others.
Quality: from well-known domestic brands for
the production of electrical extension cords, «Mi
Electronics» has made a huge breakthrough,
providing a reliable guarantee of quality.
Notice
The total power capacity of the connected electrical
equipment must not exceed rated power capacity of
the device.
It is forbidden to twist or tie a cable, do not use
the device with a twisted cable to avoid abnormal
overheating.
Grounding front of intermittent or non-standard
ground may entail a certain danger.
Do not use in damp, wet areas.
Do not disassemble the device and open its back
cover.
It is forbidden to use the device near the sources of
re, and a cord of the device must be kept away from
heat sources.
Please do not allow non-specialists to open, modify or
repair this device.
When the current exceeds 10A, overload protection
switch disconnects the power, after removing powered
devices, you can manually enable Mi Power Strip.
Due to the short circuit, overload, and for other
reasons that a USB port on the device goes into
protection state, you can not normally charge other
devices. Only after removal of defective devices or
remove the problem, you can manually resume a
power strip.
XIAOMI-MI.COM
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xiaomi Mi Power Strip at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xiaomi Mi Power Strip in the language / languages: English as an attachment in your email.

The manual is 0,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info