809227

Worcester-Bosch Greenstar Heatslave II Internal Manual

14
Zoom out
Zoom in
Previous page
1/16
Next page
14
Guarantee
Greenstar Heatslave II 2022+ – 6 721 843 979 (2022/01)
7Guarantee
7.1 Fault or breakdown
This boiler is supported in mainland UK by Worcester,
Bosch Group, part of Bosch Thermotechnology Ltd.
Specialist trained, Worcester, Bosch Group Service Engineers
are available to attend in the unlikely event that a breakdown
occurs on this boiler.
No charge will be made for parts and/or labour providing
▶ A boiler fault is found and the boiler has been installed
within the guarantee period. Reasonable evidence of this
must be supplied on request.
A call-out charge will be made where
▶ The boiler has been installed for longer than the guarantee
period.
-or-
▶ Our Field Service Engineer finds no fault with the boiler
(Note).
-or-
▶ Evidence cannot be provided that the first year service
inspection has been carried out.
(i.e. an entry in the service interval record found at the rear
of the boiler installation and servicing manual).
-or-
▶ The cause of breakdown is misuse or with other parts of
your plumbing/heating system, or with equipment not
supplied by Bosch Thermotechnology Ltd.
-or-
▶ Before calling the help line check the central heating
system pressure. If the pressure is low then check for
obvious leaks around the heating system; repair before the
system is re-pressurised.
For further support refer to the trouble shooting tool on the
website.
Please read this guide carefully to gain a good understanding of
the operation of your boiler. In the case of a suspected fault,
refer to the fault finding section of this guide.
If in doubt contact our Technical Support
In the event of an boiler fault or breakdown please contact our
Service Department. Your service administrator will arrange
for an Engineer to call with the minimum of delay. Under normal
circumstances this will be from 1 to 3 working days (excluding
weekends) for priority breakdown situations (no hot water
and/or heating).
Invoices for attendance and repair work carried out on this
boiler by any third party will not be accepted.
Boiler data label
The data label can be found on the condensate trap bracket on
the right hand side.
To access first remove the front panel:
▶ Pull control panel drawer forwards.
▶ Undo screws [A] securing the front panel to the boiler.
▶ Lift panel off bottom ledge [B] and remove from appliance.
To replace the top panel:
▶ Rest panel on bottom ledge [B].
▶ Replace the screws [A] securing the front panel to the
boiler.
▶ Push control panel drawer back into place.
(You can record this information on the inside back cover of
this manual.)
Fig. 10
No boiler fault is found on over 30% of all
service call outs.
6720813721-02.1Wo
AA
B
Data label
… 14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Worcester-Bosch Greenstar Heatslave II Internal at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Worcester-Bosch Greenstar Heatslave II Internal in the language / languages: English as an attachment in your email.

The manual is 2.19 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info