1. For your first flight make sure to be with a person experienced in flying copters. We advise you to make your first flights on a
relatively soft surface to protect the copter.
2. Find a location away from people, with a smooth surface and without obstacles. Trees, electric lines and water points in the
immediate vicinity should be avoided!
3. Place your copter on the ground about 10 feet away from you. Mind that, when you have a quadcopter, the coloured blades
indicate the front of the copter. It is easiest to position yourself behind the copter for an easier control.
4.Start with practicing throttle control; lift the copter up and down by slowly pushing the throttle up and down. if you got this under
control, push the throttle up and slowly move the ruddle stick right and left to make the copter fly small fractions left and right.
5. Draw a circle on the ground and practise within the circle to increase accuracy, from behind and front of the copter.
6. To correct the copter, just after take-off use the trim to correct position. If the copter leans left, trim to right, and if the coper
lean right, trim to left. Same for leaning forward, trim down, and when the copter leans backward, trim up.
7. Only for the X380, the one key for take of and landing works for the current flying position and should not me mistaken for the
return home button. For one key take off; press the take off button for 2 seconds, the motors will start and the coper will climb 1
meter. for one key landing; press take off button again for 2 seconds during the flight, the red light will start flashing and the copter
will start landing, afterwards the motors will turn off.
Step 1: Turn on the controller, while both switches on top of the controller are turned down, and plug the battery into the copter.
While the copter is on a horizontal surface.
Step 2: (in mode 2) hold the left joystick in the lower position and switch the heading lock switch (top left) a couple of times until
the indication light on the back of the copter turns green.
Step 3: Now spin the copter in circles in a horizontal position without the green indicator turning off for 3 rounds.
Step 4: Repeat step 2, but this time the light should be turned completely off.
Step 5: The indication light of the copter should now turn red when the copter is hold in a vertical position.
Step 6: Spin the copter in 3 circles while holding it in a vertical position, without the red light turning off.
Step 7: Put down the copter on a horizontal surface.
Step 8: Hold the left joystick in the lower position and switch the heading lock switch (top left) a couple of times just like you did at
step 2 and 4. Now the indication light should be turned full green.
Step 9: Wait about 30 to 120 seconds until the indication light flashes red/green or only green.
Engines are brushed and eventually wear out. When worn out they need to be replaced. For more informations go to
www.wltoys.eu.
Never go full speed for the first 3 flights. After 3 flights, blow out engines with air when possible.
Spare engines can be bought on www.wltoys.eu or with your reseller.
