Manual Whynter RPD-410W (page 11 of 15) (English)

727509

Zoom out

Zoom in

1/15

11 | P a g e

Removing the collected water 1. Pull the bucket out carefully.

There are two ways to remove the collected water.

1. Manual drain

 When the unit is off and the bucket is full, the unit will

beep 8 times and the Bucket Level indicator light will

flash, the digital display will also indicate P2.

 When the unit is on and the bucket is full, the

compressor shuts off but the fan runs for an

additional 30 seconds to dry any moisture on the

condenser. The unit will then beep 8 times and the

Bucket Level indicator light will flash, the digital

display will also indicate P2.

 Slowly pull out the bucket. (Fig 5) Grip the left and

right handles securely, carefully pull the bucket out

to prevent water spillage. (Fig 6) Do not put the

bucket on the floor as the bottom of the bucket is

uneven and it may tip.

 Dispose the water (Fig 7) and reinstall it to the

dehumidifier. The bucket must be installed securely

for the unit to operate.

 The unit will restart when the bucket is restored in its

correct position.

NOTES:

 When the bucket is removed, do not touch any parts

inside of the unit. Doing so may damage the unit.

 Be sure to push the bucket gently all the way into the

unit. Hitting the bucket against anything or failing to

push it in securely may cause the unit to malfunction.

 When the bucket is removed, check if there is any

excess water at the base of the unit. Wipe any visible

water inside the unit before replacing the bucket.

2. Continuous drain

Water can be automatically emptied into a floor

drain by attaching the unit with a water hose( 24mm)

(included).

 Remove the water bucket from the unit and set

aside.

 Lift up the Darin Hose Outlet cover located on the

right side of the unit (Fig.8)

Fig.5

2. Hold both sides of the

bucket evenly and pull it

out from the unit

completely.

3. Pour the water out.

Fig.7

 Insert the female threaded end of the hose to

the Drain Hose Outlet. (Fig.9a)

 Grip the hose from inside the unit and screw the hose

onto the threaded portion of the tray located in the

bucket opening.(Fig.9b)

 Make sure the hose is securely fastened to prevent

leakage. Direct the hose toward a drain or other suitable

drainage outlet. Make sure that there are no distortions

with the hose that may stop the water flow.

 Reinsert the water bucket back in the unit and make

sure that it is inserted securely.(Fig.9c)

 Select the desired humidity setting and fan speed on

the unit for continuous draining to start.

NOTE: If the unit stops operating, check if the Bucket

Level light is illuminated. If it is, remove the bucket and

empty the water and then check the seal between the hose

and the drip tray. If there is a leak, replace the hose gasket

and re-tighten the hose.

Fig.9b

Fig.9a

Fig.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Whynter RPD-410W in the language / languages: English as an attachment in your email.

The manual is 0,79 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Whynter RPD-410W Manual

Product: