484233
6
Zoom out
Zoom in
Previous page
1/8
Next page
SECTION 5: DRYING YOUR LAUNDRY (CONT)
* Drying
When starting the dryer for the first time, or starting after temporary disconnection from the gas supply,
air in the pipes will prevent ignition. To clear this air, the dryer must be started by turning the timer to a
setting of at least 30 minutes. Allow the dryer to operate for 1/2 minute before stopping the dryer. Repeat
this process until continuous burning of the gas is indicated by the neon light on the control panel.
- Open a nearby window to allow for the circulation of fresh air, even if using a vent hose.
- Open the dryer door.
- If drying sheets, load before other items, starting with one corner.
- Load clothes loosely into the drum.
- Close the dryer door.
- Dry your hands.
- Check that the timer is in the '0' position.
- Plug in the machine.
- Select correct heat setting (see programme chart around timer for recommendations).
- Select the timer to the required time setting, press start button (see programme chart on control panel for
recommendations).
- The drum will begin rotating. Reversing drum models will stop after approximately 5 minutes of normal
operation to rotate the drum in the reverse (anti-clockwise) direction for 10 seconds. The dryer does not
heat while rotating in the reverse direction.
- Should the clothes become dry before the cycle has finished, or if an excessive programme time has been
selected, the drum will continue to rotate while the thermostat will automatically regulate the heater to
reduce the risk of over-drying.
- There is an automatic 12 minute cool down period at the end of every cycle, during which the heater is
switched off. This helps to minimize creasing, and must always be used fully to avoid the risk of fire.
NEVER SWITCH THE DRYER OFF AND LEAVE A HOT LOAD IN THE DRUM - RISK OF
FIRE.
- When drying large items such as sheets, we suggest you periodically stop the dryer to redistribute the
load.
- To stop the machines during the middle of the programme simply open the door; the drum will stop
rotating automatically. To start the machine - close the door and press the start button.
- To lengthen or shorten a timed programme, open the door, reset the timer knob, close the door and press
the start button.
To lengthen or shorten a timed programme, reset the timer knob.
* After removing the dried clothes
ALWAYS CLEAN THE FILTER. Failure to clean the filter will extend drying times and could cause
the safety cut-out to operate.
- Pull the filter upwards and away from the appliance
- Remove any threads or fluff by hand or with a soft brush.
- Slide the filter back.
- Wash the filter occasionally in detergent solution and with a soft brush to remove
small particles.
- If your filter becomes damaged, replace it to ensure no damage is caused to the
dryer.
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for White Knight ECO43A at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of White Knight ECO43A in the language / languages: English as an attachment in your email.

The manual is 0,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info