Zoom out
Zoom in
Previous page
1/13
Next page
1
1


Need help? Post your question in this forum.

Forumrules


Content of pages


  • Page 1

    1 ...
  • Page 2

    CONTENTS Please read instruction for use QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE 2 INSTALLATION OF THE DRYER Page 3 SAFETY ADVICES AND GENERAL RECOMMENDATIONS Page 5 ELECTRICAL CONNECTION Page 7 DESCRIPTION OF THE DRYER Page 8 MAINTENANCE AND CLEANING THE DOOR FILTER Page 8 CLEANING THE BOTTOM FILTER Page 9 DRAINAGE SYSTEM Page 10 DOOR REVERSIBILITY Page 11 FAILURE CODES Page 12 TROUBLESHOOTING GUIDE/ AFTER-SALES SERVICE Page 13 ...
  • Page 3

    INSTALLATION OF THE DRYER • The dryer must only be transported in upright position. • The dryer shall only be transported or lifted by two persons. • The dryer is exclusively destined to dry dryable laundry in quantities which are usual for private households. • Observe the instructions given in this instruction for use and the programme chart before using the dryer. • Keep the instruction for use and the programme chart. If you pass on the dryer to another person, also give him/her the instructions for use and the programme chart. • The manufacturer declines all liability for damage to property or injury to persons or animals due to noncompliance with the directions given in this instruction for use. • The appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the tumble dryer, in such a way, that a full opening of the tumble dryer door is restricted. • Small storage rooms located inside, bath ...
  • Page 4

    • If the dryer has to be installed due to lack of space directly next to a gas or coal stove, a heat insulating plate (85 x 57 cm) has to be installed in between, whose side against the stove has to be covered with aluminium foil. • A built-in installation is not allowed for the tumble dryer. • The dryer can be built-under a worktop. A sufficient ventilation of the dryer must be assured. Assemble a ventilation grid (minimum 45 cm x 8 cm), in the rear part of the worktop where the dryer is built under. C. Insert the distance holders into the holes on both sides. C D. Fix both distance holders by turning them in clockwise direction until stop position. D 4. Assembly of distance holders To ensure a correct distance of the appliance from the wall at the rear side and allow a sufficient ventilation, distance holders have to be mounted on the dryer rear side before starting the first drying cycle. A. Remove the two distance holders from the packaging. B. The d ...
  • Page 5

    SAFETY ADVICES AND GENERAL RECOMMENDATIONS • To minimize the risk of fire in a tumble dryer, the following should be observed: • Oil-affected item can ignite spontaneously, especially when exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat cannot escape, the item can become hot enough to catch fire. Piling, stacking or storing oilaffected item can prevent heat from escaping and so create a fire hazard. • Do not tumble dry unwashed items in the tumble dryer. • Ensure that the appliance is maintained as shown in the chapter “Maintenance and cleaning”. • Ensure that the appliance is installed per the description above. • Items that have been soiled with substances such as cooking oil, acetone, alcohol, petrol, kerosene, spot removers, turpentine, waxes and wax removers must be washed in hot water with an extra amount of detergent before being dried in the tumble d ...
  • Page 6

    Packing • The packing box may be fully recycled as confirmed by the recycling symbol. Disposing of packaging and old Dryer: • The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. • Before disposing, cut off the power cable so that the dryer cannot be connected to the mains. • The symbol on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. • For more detailed information about treatment, recovery and recycling of this product please contact your local city office, your household waste disposal service or the shop where you purchased the product. Energy saving tips • Always dry a full load: depe ...
  • Page 7

    ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1 363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1 362 type and proceed as follows: 1. Remove the fuse cover (A) and fuse (B). 2. Fit replacement 13A fuse into fuse cover. 3. Reinstall both into plug. Important: The fuse cover must be reinstalled when changing a fuse and if the fuse cover is lost, plug must not be used until a correct replacement is installed. Correct replacements are identified by the color insert or the color embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 2) For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. 3) Socket outlet / plug (valid ...
  • Page 8

    DESCRIPTION OF THE DRYER A. Work top A B. Water container B C. Contact pin C D. Door: To open the door: pull the handle. To close the door: push gently until closed. E. Door filter F. Bottom filter D G. Bottom filter flap E F G MAINTENANCE AND CLEANING THE DOOR FILTER AFTER EACH DRYING CYCLE • Switch off the dryer before cleaning or carrying out maintenance. • Empty the water container at the end of each drying cycle. • Clean the door filter at the end of every drying cycle. Depending on the model of your dryer, the door filter can have different shapes. A. Take the door filter out of the dryer and open it carefully. B. Remove all lint from the lint screen. C. If the mesh is clogged and cannot be cleaned by hand, run the filter under water and scrub with a soft brush. A A B B When the door filter is clean, put it back into the dryer. Assure that it is positioned correctly before starting the next drying cycle. 8 ...
  • Page 9

    CLEANING THE BOTTOM FILTER A A. Open the bottom filter flap and set it aside. Lift up the handle of the filter and pull the bottom filter out. B. Open the filter by lifting on the latch of the filter frame. C. Take out the foam from the inside of the filter. B D. Remove the lint on the surface of the foam by hand. Afterwards, clean the foam under running water to remove any remaining lint from the foam. E. Remove the lint from both filter parts by hand. If a white substance remains on the filter mesh that cannot be removed by hand, clean the filter parts under running water. If necessary, use a soft brush. D C F. Put the foam back into the filter frame. G. Install the filter frame into the housing by inserting the tabs of the frame into the slots on the filter housing and clicking the latch into place. Please take care that the foam is not pinched between the filter parts. E F H. Clean the filter housing and the mesh inside by hand, with a damp ...
  • Page 10

    DRAINAGE SYSTEM For your convenience: The dryer can be connected directly to the sewage system of the house to avoid the emptying of the water container after each drying cycle. Place an absorbent cloth underneath to collect water spillage. C. Fix the hose to the sewage system. The height difference between the floor where the dryer stands on and the connection at the sewage system should not exceed 1 m. C A. Unplug the hose located at the upper rear part of the dryer. Notice: To avoid siphoning, the end of the hose must not be immersed in the drain water. Avoid bending and twisting the hose. B. Remove the hose out of the rear protection cover. 10 ...
  • Page 11

    DOOR REVERSIBILITY For your convenience: A In case you want to stack the dryer on a washing machine, you can reverse the door opening direction, to bring the door handle in a lower position. A. Unplug the dryer. B. Open the door. C. Using a pliers, turn the contact pin (B) in the upper part of the door by 90° and pull it out. B D. Removing the door lock: Unscrew the 2 screws above and below the door lock system. E. Press the small knob above the door lock system with a small screwdriver, move the door lock a little bit upwards and pull the door lock towards you with your finger. F. Reverse the door: Remove the two screws of the door fixation. Fasten the door again on the desired side with the 2 screws. Take care to screw in horizontal position to avoid pinching off the door seal. C G. Repositioning of the door lock: Insert the door lock on the opposite side of the door fixation. Press it completely inside the hole and move it a little down, until ...
  • Page 12

    FAILURE CODES In case of a malfunction of the dryer, one the following failure codes could be displayed. FAILURE CODE You can check yourself before calling the After-Sales Service. F01 – F04 Please call the After-Sales Service. F05 Turn the dryer OFF and unplug it. Make sure that the room temperature is between 5°C and 35°C. Wait for 1 hour. Plug the dryer back in and restart it. If the failure reoccurs, please call the After-Sales Service. F06 Turn the dryer OFF and unplug it. Make sure that the room temperature is between 5°C and 35°C. Wait for 1 hour. Plug the dryer back in and restart it. If the failure reoccurs, please call the After-Sales Service. F07 Turn the dryer OFF and unplug it. Make sure that the room temperature is between 5°C and 35°C. Unload approximately one half of the laundry from the dryer. Wait for 1 hour. Plug the dryer back in and restart it. If the failure reoccurs, please call the After-Sales Service. F10 – F24 Turn t ...
  • Page 13

    TROUBLESHOOTING GUIDE/AFTER-SALES SERVICE If a fault occurs, before contacting our After-Sales Service, perform the following checks to try to remedy the problem: Water droplets underneath the dryer: Drying takes too long / laundry is not dry enough: • Any lint on the door seal removed? • Correct programme selected? • Water container positioned correctly? • Inserted laundry too wet (Washing machine spin speed less than 800 rpm? When the spinning speed is less than 800 rpm the water container fault may occur during the drying cycle)? • Dryer levelled? • Door filter clogged (filter indicator lamp on)? • Bottom filter clogged? (refer to the chapter “Door filter and bottom filter”). • Bottom filter correctly positioned? • Any lint on the heat bottom filter seal removed? After-Sales Service If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call the After-Sales Service (refer to guarantee). ...



Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool Pure 740 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool Pure 740 in the language / languages: English as an attachment in your email.

The manual is 2,88 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool Pure 740

Whirlpool Pure 740 Quick start guide - English - 5 pages

Whirlpool Pure 740 User Manual - German - 12 pages

Whirlpool Pure 740 Quick start guide - German - 5 pages

Whirlpool Pure 740 User Manual - Dutch - 11 pages

Whirlpool Pure 740 Quick start guide - Dutch - 5 pages

Whirlpool Pure 740 User Manual - French - 11 pages

Whirlpool Pure 740 Quick start guide - French - 5 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info