330927
2
Zoom out
Zoom in
Previous page
1/10
Next page
15
INSTALLATION NOTICES
Recommendations
IMPORTANT: Disconnect the oven from the mains before carrying out any installation work
or servicing.
Installation must be carried out by a qualified technician in accordance with the manufacturer's
instructions and in compliance with local regulations.
Unpack the oven and make sure that the oven has not been damaged during transport and that the
oven door closes properly.
If you are not sure contact the dealer or the nearest service centre.
Preparing the housing unit
Kitchen units in contact with the oven must be heat resistant (90 °C min).
Cut the kitchen unit and worktop to fit before installing the oven. Carefully remove any shavings or
sawdust that could prevent the oven from running properly.
The bottom of the oven must not be accessible after installation.
During installation make sure that the sides of the oven do not touch the adjacent units.
For correct appliance operation, the minimum opening required between the worktop and
the top of the oven must not be obstructed.
Electrical connection
Regulations require that the appliance be earthed.
Connection to the mains must be carried out by a qualified technician in accordance with the
manufacturer's instructions and in compliance with local regulations.
The installer is responsible for connecting appliances correctly to the mains and for observing the safety
regulations.
The oven power cable must be long enough to connect the built-in oven to the mains.
Observance of safety directives requires that a multi-pole switch with a minimum contact gap of 3 mm
be used for the installation.
After the oven has been installed, the electrical components must be inaccessible.
Connecting the oven to the power supply
Make sure that the voltage indicated on the rating plate is the same as the mains voltage.
The rating plate is on the front edge of the oven (visible when the door is open).
If the power cable is not present proceed as follows:
1.
Remove the two fastening screws of the terminal box cover located on the bottom part of the
oven's rear covering.
2.
Remove the cover to gain access to the terminal box and insert the power cable (see table) through
the opening located on the bottom of the oven.
3.
Connect the cable to the terminal box, tighten the screws as far as they will go and secure it to the
cable fastener.
4.
Put the cover back on by inserting the two blades in the slots and fasten it with the two screws.
Power supply cable table
N° of conductors Type of cable
1N+
~
H05 RR-F 3 X 1.5 mm²
61002009GB.fm Page 15 Wednesday, September 17, 2008 11:16 AM
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool nutid ov9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool nutid ov9 in the language / languages: English as an attachment in your email.

The manual is 0,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool nutid ov9

Whirlpool nutid ov9 Quick start guide - Dutch - 4 pages

Whirlpool nutid ov9 User Manual - Dutch - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info