Zoom out
Zoom in
Previous page
1/9
Next page
10
CONTENTS
QUICK REFERENCE GUIDE
PROGRAMME CHART
PREPARING THE LAUNDRY
SELECTING A PROGRAMME AND OPTIONS
STARTING AND COMPLETING A PROGRAMME
CHANGING A PROGRAMME
INTERRUPTING A PROGRAMME
DAILY MAINTENANCE AND CLEANING
INSTRUCTIONS FOR USE
BOOKLET
BEFORE USING THE DRYER / CONNECTIONS
PAGE
11
ELECTRICAL CONNECTION
PAGE
12
PRECAUTIONS AND GENERAL RECOMMENDATIONS
PAGE
13
DESCRIPTION OF THE DRYER
PAGE
14
DRAINAGE SYSTEM
PAGE
15
DOOR REVERSIBILITY / CHILD SAFETY LOCK
PAGE
16
HEAT EXCHANGER
PAGE
17
TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE
PAGE
18
1


Need help? Post your question in this forum.

Forumrules


Content of pages


  • Page 1

    CONTENTS QUICK REFERENCE GUIDE PROGRAMME CHART PREPARING THE LAUNDRY SELECTING A PROGRAMME AND OPTIONS STARTING AND COMPLETING A PROGRAMME CHANGING A PROGRAMME INTERRUPTING A PROGRAMME DAILY MAINTENANCE AND CLEANING INSTRUCTIONS FOR USE BOOKLET 10 BEFORE USING THE DRYER / CONNECTIONS PAGE 11 ELECTRICAL CONNECTION PAGE 12 PRECAUTIONS AND GENERAL RECOMMENDATIONS PAGE 13 DESCRIPTION OF THE DRYER PAGE 14 DRAINAGE SYSTEM PAGE 15 DOOR REVERSIBILITY / CHILD SAFETY LOCK PAGE 16 HEAT EXCHANGER PAGE 17 TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE PAGE 18 ...
  • Page 2

    BEFORE USING THE DRYER / CONNECTIONS 1. Removing the packaging and check • After unpacking, make sure that the dryer is undamaged. If in doubt, do not use the dryer. Contact After-Sales Service or your local retailer. • Keep the packaging materials (plastic bags, polystyrene parts, etc.) out of reach of children, as they are potentially dangerous. • Remove the protective foil from the control panel. 2. Electrical Connections • Electrical connections must be carried out by a qualified technician in compliance with the manufacturer's instructions and current standard safety regulations. • Electrical connection must comply with local Electricity Board regulations. • Voltage information, power consumption and the required fuse protection is shown on the rating plate mounted at the rear of the dryer. • The manufacturer cannot accept any liability for personal injury or damage to property resulting from failure to adhere to these instructions. • The dryer must be earthe ...
  • Page 3

    ELECTRICAL CONNECTION 1) For Great Britain only Warning - this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1363A 13amp fused plug, to change a fuse in this type of plug use an A.S.T.A. approved fuse to BS 1362 type and proceed as follows: 1.Remove the fuse cover (A) and fuse (B). 2.Fit replacement 13A fuse into fuse cover. 3.Refit both into plug. Important: The fuse cover must be refitted when changing a fuse and if the fuse cover is lost the plug must not be used until a correct replacement is fitted. Correct replacement are identified by the colour insert or the colour embossed in words on the base of the plug. Replacement fuse covers are available from your local electrical store. 2) For the Republic of Ireland only The information given in respect of Great Britain will frequently apply, but a third type of plug and socket is also used, the 2-pin, side earth type. 3) Socket outlet / plug (valid for both ...
  • Page 4

    PRECAUTIONS AND GENERAL RECOMMENDATIONS 1. Packing The packing box may be fully recycled as confirmed by the recycling symbol . 2. Energy saving tips • Always dry a full load: depending on the type of laundry and the programme/drying time. • By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle. • Do not overdry the laundry. • Clean the lint filter after every drying cycle. • Place your dryer in a room with a temperature between 15° C and 20° C. In case of higher temperature ventilate the room. • Always select the correct programme/drying time for the load in order to obtain the desired drying results. • Select the gentle option only with small loads. • When drying cotton, for example. dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at th ...
  • Page 5

    DESCRIPTION OF THE DRYER A. Work top. B1. Water Container bottom version or B2. Water Container top version. C. Contact pin. D. Door: To open the door: pull the handle. To close the door: push gently until closed. E. Filter. F. Child Safety Lock. G. Button for heat exchanger flap opening. H. Heat exchanger. A B2 C D F E G H B1 Reminder - Maintenance and Cleaning Clean the lint filter at the end of every drying cycle. Open the door Pull the filter upwards Open the filter Remove lint using a soft brush or your fingertips Close the filter Push the filter back into place. Heat exchanger Clean the heat exchanger at least every 3 months (See "CONDENSER" chapter). Wipe away any lint/fluff from the door seal and interior using a damp cloth. 14 ...
  • Page 6

    DRAINAGE SYSTEM For water container top only B To avoid having to empty the water container at the end of each cycle, the condensation water can be drained away. Note: if the drain hose is not supplied, the optional accessory AMH 883 kit, available at your dealer, should be used. The connection for direct draining is at the rear of the dryer. A. Place an absorbent cloth underneath to collect water spillage. B. Remove the hose located at the lower rear part of the dryer and insert it in the nearby hole. C. Fix the hose (length: 1.5 m) to the outlet connection. The height difference between the two drainage connections should not exceed 1m. Notice: To avoid siphoning, the end of the hose must not be immersed in the drain water. Avoid bending and twisting the hose. C 15 ...
  • Page 7

    DOOR REVERSIBILITY / CHILD SAFETY LOCK Door Reversibility C A. Unplug the dryer. B. Open the door. C. Using a spanner, turn the contact pin in the upper part of the door by 90° and remove it. D. Unscrew the 2 screws of the door hinge and remove the door. E. Removing the door lock: Unscrew the 2 screws above and below the door lock system. Lift the door lock from the bottom, sliding it upwards about 1.5 cm, and remove it. F. Reverse the door: Fasten the door on the desired side with the 2 screws. G. Insert the door lock system on the opposite side of the hinge fixation and push it down 1.5 cm. H. Fix the 2 screws above and below the door lock system. I. Take care not to reverse the sense of the door lock system. The child safety must be above the locking mechanism. J. Replace the contact pin in the inside of the door (top). C D Child Safety Lock How to use the child safety lock 1. Open the door. 2. Using a coin or a screwdriver, turn the plastic screw ...
  • Page 8

    HEAT EXCHANGER Before cleaning or carrying out maintenance, switch off the dryer. Clean the heat exchanger at least every three months, proceeding as follows: A A. Open the door and press the heat exchanger flap button on the bottom of the door entrance. B. The heat exchanger flap opens. C. Fold the heat exchanger handle upwards to the horizontal position and remove the heat exchanger. D. Clean the heat exchanger under running water by turning it around to reach all sides. E. Wipe away dust and lint from the seals and the heat exchanger. F. Remove the lint in the heat exchanger housing. Keep the drainage hole (left side in front in the housing) free from lint. G. Replace the condenser in its housing (TOP or HAUT mark upwards) and press the handle. H. Close the flap. B C The heat exchanger aluminium plates may become discoloured over time. D 17 ...
  • Page 9

    TROUBLESHOOTING GUIDE / AFTER-SALES SERVICE Troubleshooting Guide After-Sales Service If a fault occurs, before contacting our AfterSales Service, make the following checks to try and remedy the problem: If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call our After-Sales Service (refer to guarantee). Drying takes too long / laundry is not dry enough: • Was the correct programme selected? • Was the inserted laundry too wet (Washing machine spin speed less than 800 rpm? When the spinning speed is less than 800 rpm the water container fault may occur during the drying cycle)? • Is the lint filter dirty (filter indicator lamp on)? • Is the heat exchanger dirty (refer to the Instructions for use)? • Is the ambient temperature too high? The dryer does not operate: (after a power failure and/or interruption to the mains supply, always press the Start/Pause button). • Is the plug properly inserted into the ...



Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool awz 881 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool awz 881 in the language / languages: English as an attachment in your email.

The manual is 0,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool awz 881

Whirlpool awz 881 User Manual - German - 8 pages

Whirlpool awz 881 User Manual - Dutch - 8 pages

Whirlpool awz 881 User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info