Manual Whirlpool awo 9361 (page 2 of 2) (English)

307927

Zoom out

Zoom in

1/2

5019 301 05609

Whirlpool is a registered trademark of Whirlpool USA

Add the detergents as described in the programme

table or in the chapter “Detergents and Additives”

in the booklet.

1. Turn the

programme selector knob

to the

desired programme.

2. The remaining time display shows the duration

of the chosen programme (in hours and

minutes) and the indication of the

“Start/

Pause”

button is flashing.

3. The programme sequence and the predefined

spin speed indication corresponding to the

selected programme lights up.

The recommended temperature (see the

indicator) can be altered by pressing “

/-” button.

Selecting any option the indication lights up.

When the combination of programme, additional

options and temperature is not possible, the indication

lights switch off automatically. Unsuitable

combinations of options are deselected automatically.

“Easy Ironing” button

• Can be used together with “Cotton”, “Synthetics”

and “Daily” programmes to make ironing easier.

• Increases the water quantity and the clothes are

spun very soft.

“Eco plus” button

• With a modified temperature profile and a slightly

prolonged washing duration, the optimum

combination of excellent washing result and even

lower energy consumption can be achieved.

“Prewash” button

• Only for heavily soiled loads (for example sand,

granular dirt) sensible. The cycle time increases

approximately 15 min.

“Intensive Rinse” button

• More water and a longer time in rinse cycle is added.

• This option is particularly suitable for areas with

very soft water, washing baby linen and helps

people with allergies.

“Rinse Hold” button

• The laundry remains in the last rinse water

without progressing to the final spin cycle to avoid

creasing and prevent colours from changing.

• This option is particularly recommended for the

programme “Synthetics”, “Daily” and “Delicates”.

• This function is particularly useful if you want to

postpone spinning to a later time, or if you want

to drain only.

Note:

The programme stops to “Rinse Hold” at

the time the “Rinse Hold” light in the programme

sequence indication is on.

Terminate the “Rinse Hold” option:

• Press the “Rinse Hold” button again; the

programme will terminate automatically with the

final spin cycle for the present wash programme.

CONSUMPTION DATA

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)*

Cotton 95 6.0 54** 1.90 2:00

Cotton 60 6.0 49 1.14 2:20

Cotton with “Eco plus”*** 60 6.0 49 1.02 2:30

Cotton 40 5.0 44 0.60 2:05

Synthetics 60 2.5 55 0.80 1:30

Synthetics 40 2.5 55 0.60 1:20

Daily 40 3.0 45 0.50 1:00

Superrapid 30 3.0 37 0.40 0:30

Delicates 30 1.5 60 0.50 0:45

Wool 30 1.0 60 0.30 0:40

Handwash 30 1.0 45 0.30 0:40

Prewash cycle might increase programme duration. Consumption values were measured in normalized conditions in compliance

with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the

water supply pressure and temperature, the load and the type of wash.

* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household

conditions applicable at that time.

** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the

water out.

*** Reference Programme for Energy Label

ADD DETERGENTS, CLOSE THE DOOR

AND SELECT THE PROGRAMME

SELECT ANY DESIRED OPTION

• If you do not wish to spin the clothes, turn the

programme selector knob counterclockwise to

the “Drain” programme and press the

“Start/Pause”

button again when the indication

next to it is flashing.

“Spin Speed” button

• Every programme has an automatic predefined

maximum spin speed.

• Press the button to set another spin speed.

• If the spin speed “0” is selected, the final spinning is

cancelled but intermediate spin peaks remain

during rinse. The water is drained out only.

The “Start Delay” allows to run the machine at the

consumer’s convenience, for example at night when

electricity is cheaper.

• Select programme, temperature and options.

• Press the “Start Delay” button to select the delay

time by 1 to 23 hours;

•Press the

“Start/Pause”

button.

The indication next to the “Start Delay” button

lights up and goes off when the programme starts.

• The time delay indication disappears when the

programme starts and it is replaced by the

remaining time.

• The number of hours preselected can later be

reduced pressing again the “Start Delay” button.

To cancel the “Start Delay”

..before you press the “Start/Pause” button:

• Turn the programme selector to the

“

Off

/0”

position.

• Reselect the desired programme and options and

press

“Start/Pause”

button to start the programme.

..after having pressed the “Start/Pause” button:

• Press the “Reset” button for at least 3 seconds -

the start delay time disappears from the

remaining time indication,

• then either start the chosen programme by

pressing the

“Start/Pause”

button twice

• or turn the programme selector knob to the

“Off/0” position and chose another programme.

Open the tap and press the

“Start/Pause”

button. The

indication next to the

“Start/Pause”

button lights up.

The indications show the sequence reached in the

programme. After starting the programme, the

sequence indication runs from left to right through

Wash, Rinse, Spin.

When the sequence of the programme is finished

the corresponding indication goes out.

“Water Tap Closed”

The appliance has no or insufficient water supply.

Open the water tap; if the indication still lights up,

refer to the “Troubleshooting Guide” in the

Instructions for Use.

“Clean Pump”

Waste water is not pumped out. Check whether the

drain hose is kinked or the filter must be cleaned; in

the latter case refer to the Instructions for Use

(“Removing the Filter”).

“Door Locked”

As long as a washing programme is running, the

lamp lights up to show that the door cannot be

opened. When the indication goes off, the door can

be opened again.

“Water Stop”

Lighting up of the water stop indication can be

caused by a leak in the appliance or hose. Please

refer to the “Troubleshooting Guide” in the

Instructions for Use.

• The remaining time is on “0:00” and all the

lights of the programme sequence indication

are off.

1. Turn the programme selector to the

“

Off

/0”

position.

2. Close the water tap.

3. Open the door and unload the machine.

4. Leave the door ajar to allow the drum to dry out.

1. Press the

“Start/Pause”

button to pause the

programme. The light flashes.

2. Select the new programme (with temperature),

any options and another spin speed if you want.

3. Press the

“Start/Pause”

button again. The

new programme continues at the same position

where the previous programme was

interrupted. Do not add detergent for this

programme.

The

“Reset”

button cancels a programme before

the end.

•Press the

“Reset”

button for at least 3 seconds.

Any existing water is drained out before the

door can be opened.

START DELAY

PROGRAMME START

RED INDICATIONS

PROGRAMME END

CHANGE THE PROGRAMME,

TEMPERATURE, OPTIONS AFTER

PROGRAMME START

CANCEL (RESET) A RUNNING

PROGRAMME BEFORE THE END

3gb05609.fm Page 2 Friday, June 4, 2004 11:57 AM

Black process 45.0° 100.0 LPI

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool awo 9361 in the language / languages: English as an attachment in your email.

The manual is 0,2 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool awo 9361

Whirlpool awo 9361 User Manual - English - 13 pages

Whirlpool awo 9361 User Manual - English - 14 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Whirlpool awo 9361 Manual

Product: