306163
2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 301 15012
Whirlpool is a registered trademark of Whirlpool USA.
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with Standard IEC 60 456. The data on the Energy Label refer to programme Coloured Cotton
60° C. Consumption data in the home may vary with respect to the values in the table in relation to the water supply
pressure and temperature, the load and the type of wash.
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the
household conditions applicable at that time.
**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
Add the detergent as described in the chapter
Detergents and Additives in the booklet.
1. Turn the
programme selector knob
to the
desired programme.
2. The remaining time display shows the duration of
the chosen programme (in hours and minutes)
and the pilot lamp of the
Start/Pause
button
is flashing.
3. The programme sequence and the predefined
spin speed indication corresponding to the
selected programme lights up.
The recommended temperature (see the indicator)
can be altered by pressing
+
or
-
button.
Selecting any option the pilot lamp lights up.
An audible tone sounds if the combination of
programme, additional options and temperature
is not possible. Unsuitable combinations of
options are deselected automatically.
Eco Wash button
The duration of the wash is extended and the
temperature reduced to save up to 40% of energy
maintaining good washing results.
Easy Ironing button
Can be used together with Cotton and Synthetics
programmes to make ironing easier.
Increases the water quantity and the clothes are
spun very soft.
Prewash button
Only for heavily soiled loads (for example sand,
granular dirt) sensible. The cycle time increases
approximately 15 min.
Intensive Rinse button
A further rinse cycle is added.
This option is particularly suitable for areas with
very soft water, washing baby linen and helps
people with allergies.
Rinse Hold button
The laundry remains in the last rinse water
without progressing to the final spin cycle to
avoid creasing and prevent colours from
changing.
This option is particularly recommended for the
programme Synthetics or Delicates.
This function is particularly useful if you want to
postpone spinning to a later time.
CONSUMPTION DATA
Programme
Temperature Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approx. Programme
Duration
(hours : minutes*)
White Cotton 95 5.0 44** 1.60 1:55
Coloured cotton 60 5.0 39 0.95 2:00
Coloured cotton 40 5.0 39 0.55 2:00
Synthetics 60 2.5 55 0.70 1:30
Synthetics 40 2.5 50 0.50 1:15
Rapid Plus 30 3.0 35 0.40 0:30
Delicates 30 1.5 50 0.50 0:45
Wool 40 1.0 50 0.50 0:40
Handwash 30 1.0 35 0.40 0:35
ADD DETERGENTS, CLOSE THE DOOR AND SELECT
THE PROGRAMME
SELECT ANY DESIDERED OPTION
Note:
the programme stops to Rinse Hold at the
time the Rinse Hold button light flashes.
Terminate the Rinse Hold option:
Press the Rinse Hold button again; the
programme will terminate automatically with
the final spin cycle for the present wash
programme.
If you do not wish to spin the clothes, turn the
programme selector knob to the Drain
programme and press the
Start/Pause
button again.
Spin Speed Reduction button
Every programme has an automatic predefined
maximum spin speed.
Press the button to set another spin speed.
If the spin speed
0
is selected, the final
spinning is cancelled. The water is drained out
only.
The Start Delay allows to run the machine at the
consumers convenience, for example at night
when electricity is cheaper.
Press the Start Delay button to select the
delay time by 1 to 19 hours;
Press the
Start/Pause
button. The Start
Delay light flashes until the programme starts.
The time delay indication disappears when the
programme starts and its replaced by the
remaining time.
The number of hours preselected can later be
reduced pressing again the Start Delay
button.
To cancel the Start Delay.
Turn the programme selector to the “”
position.
Reselect the desired programme and options
and press the
Start/Pause
button.
Open the tap and press the
Start/Pause
button.
The pilot lamp of the
Start/Pause
button lights up.
The indicator lamps show the sequence reached in
the programme. After starting the programme, the
sequence indication runs from left to right through
Wash, Rinse, Spin.
When the sequence of the programme is finished
the corresponding lamp goes out.
During the first 15 minutes of the cotton and
synthetics programmes the door can be opened for
adding further laundry.
The door can be opened when the Door Open
indication is shining.
The remaining time is on 0:00 and all the
lights of the programme sequence indication
are off.
A short audible tone sounds three times.
1. Turn the programme selector to the
“”
position.
2. Turn the water supply tap off.
3. Open the door and unload the machine.
1. Press the
Start/Pause
button to pause the
programme. The light flashes.
2. Select the new programme (with temperature),
any options and another spin speed if you want
it.
3. Press the
Start/Pause
button again. The
new programme continues at the same position
where the previous programme was
interrupted. Do not add detergent for this
programme.
1. Press the
Start/Pause
button to pause the
programme. The light flashes.
2. Set the programme selector to Drain. The
spin indicators show
0
and the remaining
time shows 0:02.
3. Press the
Start/Pause
button to start the
drain programme.
START DELAY
PROGRAMME START
DOOR LOCK
PROGRAMME END
CHANGE THE PROGRAMME, TEMPERATURE,
OPTIONS AFTER PROGRAMME START
CANCEL A PROGRAMME BEFORE THE END
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool awm 8163 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool awm 8163 in the language / languages: English as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool awm 8163

Whirlpool awm 8163 User Manual - English - 16 pages

Whirlpool awm 8163 User Manual - English - 13 pages

Whirlpool awm 8163 User Manual - German - 16 pages

Whirlpool awm 8163 User Manual - Dutch - 13 pages

Whirlpool awm 8163 User Manual - Dutch - 15 pages

Whirlpool awm 8163 Quick start guide - French - 2 pages

Whirlpool awm 8163 User Manual - French - 15 pages

Whirlpool awm 8163 User Manual - Italian - 13 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info