Zoom out
Zoom in
Previous page
1/18
Next page
1
1


Need help? Post your question in this forum.

Forumrules


Content of pages


  • Page 1

    1 ...
  • Page 2

    CONTENTS READ INSTRUCTIONS FOR USE! INSTRUCTIONS FOR USE SAFE INSTALLATION AND USE Page 3 INTENDED USE Page 7 INSTALLATION Page 8 DESCRIPTION OF THE DRYER Page 9 CLEANING AND MAINTENANCE Page 10 CLEANING THE LINT FILTER Page 10 CLEANING THE HEAT EXCHANGER Page 11 DRAINAGE SYSTEM Page 12 DOOR REVERSIBILITY Page 14 ENERGY SAVING/AUTOMATIC SWITCH-OFF FUNCTION Page 15 TROUBLESHOOTING GUIDE/AFTER-SALES SERVICE Page 16 DISPOSAL Page 18 QUICK REFERENCE GUIDE INDICATORS AND OPTIONS PROGRAMME CHART RUNNING A PROGRAMME TROUBLESHOOTING / MAINTENANCE CONSUMPTION DATA 2 ...
  • Page 3

    SAFE INSTALLATION AND USE To avoid injuries, damages on the dryer and its surrounding area or even a fire, you must observe the instructions below. Packaging, damages, handling • Keep the packaging foil away from children; danger of suffocation. • Do not operate the dryer if it has been damaged during transport or later. Inform the After-Sales Service. • If the dryer was exposed to the cold before delivery, keep it at room temperature for a few hours before installation. Cold temperatures can affect the proper functioning of electronic parts. • Never lift your dryer by holding it on extruding parts (e.g. door) or on the worktop; parts might loosen or break and persons might get injured. • For lifting the dryer, at least 2 persons are necessary, to avoid accidents. Location and surrounding area • The dryer is appropriate for indoor use only. • Do not install the dryer in rooms with poor ventilation. If you want to install it in a small storage room, toilet, bathroom or s ...
  • Page 4

    • If you want to install the dryer under a worktop, make sure that a ventilation grid (minimum 45 x 8 cm) is inserted in the rear part of the worktop where the dryer will be installed, to assure sufficient ventilation. Stacking on a washing machine • If you want to place the dryer on top of your washing machine, first contact our After-Sales Service or your specialist dealer to verify if this is possible. Stacking of a dryer is only admitted if the dryer and your washing machine are compatible, and if an appropriate stacking kit is available through our After-Sales Service or your specialist dealer by which the dryer can be safely fixed on the washing machine. Electrical connection • The dryer must only be connected to an earthed socket which is in compliance with the current safety regulations and which is appropriate for the values regarding voltage, power consumption and protection requirements as they are indicated on the rating plate on the rear of the dryer. • ...
  • Page 5

    • Do not trap the mains cable between the dryer and the wall, to prevent damages on the cable. • Do not operate the dryer if the mains cable or plug shows damages. • Before doing any maintenance on the dryer, disconnect it from the mains supply, to avoid dangers. • If necessary, the mains cable can be replaced; the replacement must only be done by our After-Sales Service or by a qualified technician, to avoid dangers. • When using a residual current circuit breaker (RCCB), only use a model marked with Children and handicapped people • Children must not play with the dryer • Children younger than 3 years should be kept away from the dryer, unless they are continuously supervised. • The dryer can be operated by children from the age of 8 years up, as well as by people with reduced physical, sensory or mental capabilities or lack of experience and knowledge, provided they are supervised or instructed regarding the safe use of the dryer and they understand the dangers res ...
  • Page 6

    • • • • • • • • • Remove all objects from pockets such as lighters and matches. Do not use flammable cleaning agents. Do not use the tumble dryer if chemicals have been used for cleaning. Fabric softeners or similar products must be used as specified by the fabric softener instructions. Never stop the tumble dryer before the end of the drying cycle, unless all items are quickly removed and spread out so that the heat is dissipated. The final phase of a drying cycle always occurs without heat (cool down phase), to ensure that the laundry items are left at a temperature which does not cause damage to the laundry. Clean the door filter after each drying cycle (see paragraph CLEANING THE DOOR FILTER). Keep the surrounding area of the dryer free from lint. Always set the programme knob to the Off-position “O” after programme end, to reduce the risk that the dryer might be started accidentally. Drying clothes with buckles or using dryer balls may impact the surfac ...
  • Page 7

    INTENDED USE This appliance is destined to dry laundry which is marked to be appropriate for being treated in a dryer, in quantities which are usual for private households. • Observe the instructions given in these Instructions for Use and in the Quick Reference Guide when using the dryer. • Keep these Instructions for Use and the Quick Reference Guide; if you pass on the dryer to another person, also give him/her Instructions for Use and Quick Reference Guide. 7 ...
  • Page 8

    INSTALLATION For installing your dryer, you must observe the instructions of chapter SAFE INSTALLATION AND USE. • Carefully level the dryer by adjusting the four feet; check the correct leveling with a level. • Before running the first drying cycle, ensure that the water container is fully pushed inside and that the bottom filter is correctly positioned (see chapter DESCRIPTION OF THE DRYER). • Also make sure that all hoses of the drainage system are connected as shown in the picture below. If possible you can drain the water directly into the domestic plumbing system. This will avoid having to empty the water container at the end of each drying cycle since the condensation water can be directly drained away (see chapter DRAINAGE SYSTEM). Electrical connection for Great Britain/Ireland 1) For Great Britain only Warning – this appliance must be earthed Fuse replacement If the mains lead of this appliance is fitted with a BS 1 363A 13 amp fused plug, to change a fuse in ...
  • Page 9

    3) Socket outlet / plug (valid for both countries) If the fitted plug is not suitable for your socket outlet, please contact Whirlpool Service for further instruction. Please do not attempt to change plug yourself. This procedure needs to be carried out by a qualified Whirlpool technician in compliance with the manufactures instructions and current standard safety regulations. DESCRIPTION OF THE DRYER A. B. C. D. Work top Water container Contact pin Door: To open the door: pull the handle. To close the door: push gently until closed. E. Filter F. Heat exchanger G. Heat exchanger flap F 9 ...
  • Page 10

    CLEANING AND MAINTENANCE Before any cleaning or maintenance, switch off the dryer. AFTER EACH DRYING CYCLE • Clean the lint filter at the end of every drying cycle. • Empty the water container at the end of each drying cycle. EACH MONTH • Clean the heat exchanger at least every month (see “Cleaning the heat exchanger” on the next page). Cleaning the lint filter Depending on the model of your dryer, the lint filter can have different shapes. Clean the lint filter after every drying cycle, or when the lint filter indicator lamp lights up, proceeding as follows: A. Remove the completed laundry out of the dryer before removing the lint filter. B. Take the lint filter out of the dryer and carefully open the filter. C. Carefully remove the complete lint from the lint screen. D. If the mesh is clogged and cannot be cleaned by hand, run the filter under water and scrub with a soft brush. When the lint filter is clean, put it back into the dryer. Make sure that th ...
  • Page 11

    Cleaning the heat exchanger Before any cleaning or maintenance, switch off the dryer. Clean the heat exchanger at least every month, or whenever the heat exchanger indicator lamp lights up (if available on your model), proceeding as follows. A. Open the heat exchanger flap. A B. Turn the two locking bars at the side of the heat exchanger towards the middle, to the horizontal position, and pull the heat exchanger out. B C. Hold the heat exchanger as shown in the picture. Clean it under running water by turning it around to reach all sides, especially in front and behind. Wipe away dust and lint from the heat exchanger seals and plates. Clean the inside of the heat exchanger plates under running water, from the front side to the back. C D. Remove the lint from the heat exchanger housing by hand or with a damp cloth. Clean the entire housing from the back to the front side, ensuring that all lint is removed. D • Fully insert the heat exchanger back in ...
  • Page 12

    DRAINAGE SYSTEM For your convenience: The dryer can be connected directly to the sewage system of the house to avoid the emptying of the water container after each drying cycle. Place an absorbent cloth underneath to collect water spillage. A. Unplug the hose located at the upper rear part of the dryer. B. Remove the white hose from the hose fixation. 12 ...
  • Page 13

    C. Fix the hose to the sewage system. The height difference between the floor where the dryer stands on and the connection at the sewage system should not exceed 1 m. max. 1 m NOTE: To avoid siphoning, the end of the hose must not be immersed in the drain water. Avoid bending and twisting the hose. 13 ...
  • Page 14

    DOOR REVERSIBILITY For your convenience: A In case you want to stack the dryer on a washing machine, you can reverse the door opening direction, to lower the position of the door handle. Unplug the dryer. A. Open the door. B. Using a spanner, turn the contact pin in the top part of the door through 90° and pull it out. B C. Removing the door lock: Unscrew the 2 screws above and below the door lock system. D. Press the small knob above the door lock system with a small screwdriver, move the door lock a little bit upwards and pull the door lock towards you with your finger. C E. Reverse the door: Remove the two screws of the door fixing plate. Fasten the door again on the desired side with the 2 screws. Take care to tighten the screws horizontally to avoid pinching off the door. Repositioning of the door lock: Insert the door lock on the opposite side of the door fixing plate. Press it fully into the hole and move it downwards slightly, until the sma ...
  • Page 15

    ENERGY SAVING For Dryers with Energy Label according to Directive 2010/30/EU The Energy Label contains information on performance and consumption of your dryer: The bold black arrow marks the energy efficiency class (A+++ = most efficient / D = least efficient). Power consumption per year Type of dryer Maximum load capacity Drying time Noise level drying Condensation efficiency Automatic switch-off function Your dryer is designed to save energy. For that reason, the dryer will switch off automatically a short time after programme end. When a programme is selected but not yet started, the dryer will switch off after a few minutes. To switch the dryer on again, turn the programme selector to "Off / O" and afterwards to the desired programme again. Energy saving tips • • The programme which is the most energy-efficient for drying normal wet cotton laundry is specified in the separate Quick Reference Guide; it is the reference programme for the Ene ...
  • Page 16

    • • • • • • • • • Always dry a full load: depending on the type of laundry and the programme/drying time. For detailed information, refer to the separate Quick Reference Guide. Use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle. Do not overdry the laundry. Clean the door filter after every drying cycle. Clean the bottom filter after every fifth drying cycle. Place your dryer in a room with a temperature between 15 °C and 20 °C. In case of higher temperature, ventilate the room, e.g. open the window. Always select the correct programme/ drying time for the load in order to obtain the desired drying results. Select the gentle option only with small loads. When drying cotton, dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dr ...
  • Page 17

    Lint filter, water container or heat exchanger indicator lamp on: • Lint filter clean? • Water container empty? • Water container correctly positioned? • Heat exchanger clean and correctly positioned? Water droplets underneath the dryer: • Heat exchanger correctly positioned? • All lint on the heat exchanger seal removed? • Any lint on the door seal removed? • Water container positioned correctly? • Dryer levelled? After-Sales Service If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call the After-Sales Service (refer to guarantee). Please indicate: • The nature of the fault. • The dryer type and model. • The service code (the number after the word Service on the adhesive rating plate) on the lower side of the door opening. • Your full address and phone number. Manufacturer: Whirlpool Europe s.r.l. Viale Guido Borghi 27 21025 Comerio (VA) Italy EC Declaration of Conformity • • • This dryer has bee ...
  • Page 18

    DISPOSAL • This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). • By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. Packing • The packing box is 100% recyclable, as confirmed by the recycling symbol. Disposing of packaging and old appliances: • The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. • Before disposing, cut off the power cable so that the dryer cannot be connected to the mains. • The symbol on the product or on the documents accompanying the product indicates that this appliance may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic ...



Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool AWB 866 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool AWB 866 in the language / languages: English as an attachment in your email.

The manual is 0,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool AWB 866

Whirlpool AWB 866 Quick start guide - English - 6 pages

Whirlpool AWB 866 User Manual - German - 18 pages

Whirlpool AWB 866 Quick start guide - German - 6 pages

Whirlpool AWB 866 User Manual - Dutch - 17 pages

Whirlpool AWB 866 Quick start guide - Dutch - 6 pages

Whirlpool AWB 866 User Manual - French - 17 pages

Whirlpool AWB 866 Quick start guide - French - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info