71454
4
Zoom out
Zoom in
Previous page
1/4
Next page
GB
REPLACING THE LIGHT BULB
Always disconnect the refrigerator from the power supply before
replacing any light bulbs.
If the inside light is not working:
Remove the light cover using a small screwdriver. Put the tip of
screwdriver into upper rectangular hole, press down the catch
for unblock and pull cover towards outside.
Check the bulb and if necessary replace it.
Pull the bulb towards the outside of the lamp holder. Put the
new one pushing connectors to the sockets of lamp holder. It is
used a special bulb, which does not unscrew. This bulb is
available only from our After-sales Service. Replace using
maximum 15W bulb.
Assembly again the light cover pushing in its place, hearing "click
effect". Do not leave not covered bulbs.
Warning:
After removing the light cover in order to cleaning, unplug the
appliance at first. Use only slightly wet wash cloth. Do not touch
the bulbs. Keep special precautions.
FRESH CONTROL COMPARTMENT UNBLOCK
Press the both locks, pull the drawer out.
Changing the position of shelves:
Your refrigerator allows you to change the position of shelves
according to your needs.
To remove the shelf, pull it forward to the stop.
Keep the lock pressed down as shown in the picture detail, and
pull the shelf frontward until it is released. The locks can be
pressed separately.
Pull the pins outward to remove the rails.
Remove the rails as in the picture and place them where you
wish.
To place the rails observe the inscription “ ” written on the
rail.
After that, place the shelf on them.
Checking the temperature
After the appliance has been switched on for at least 24
hours, can be checked if the temperature in the
refrigerator is correct and, if necessary, adjust the
setting as indicated in the user instructions (see
"Adjusting the temperature").
The internal temperature of the refrigerator depends
on various factors such as the ambient temperature of
the room, the amount of food stored and how often
the door is opened. These factors should be taken into
account when setting the appliance.
If the symbol is switched OFF, it means that the
temp. inside the refrigerator is too warm; in this case
adjust the temp,. setting and wait for at least 12 hours
before checking again if the temp, is correct.
IMPORTANT:
after opening the door or loading the
refrigerator, it is normal if the symbol is switched OFF
for some time, especially if room temperature is very
warm.
Function indicating the necessity to replace the
Anti-bacterial filter
The replacement of the filter is described on the first
page of this Product Sheet.
After connecting the appliance, the three-segment
icon is displayed.
The segments will sequentially go off:
- after 2 months
- after 4 months
- after 6 months
After 6 months of operation, the alarm icon and
icon will be displayed, indicating that it is necessary
to replace the filter. After replacing the filter, keep the
"OK" button pressed for about 5 seconds, until the
alarm icon goes off and the three-segment icon
reappears. It is possible to switch the icon off until
the filter is replaced (for about 6 hours) by pressing the
"OK" button.
Cleaning
Press the Stand-by button, which allows you to switch
off the refrigerator compartment alone, keeping the
freezer on. The refrigerator compartment can now be
emptied and cleaned.
V
5019 637 01014
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool ARC 7558 IX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool ARC 7558 IX in the language / languages: English as an attachment in your email.

The manual is 0,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool ARC 7558 IX

Whirlpool ARC 7558 IX User Manual - English - 6 pages

Whirlpool ARC 7558 IX Quick start guide - German - 4 pages

Whirlpool ARC 7558 IX User Manual - German - 6 pages

Whirlpool ARC 7558 IX Quick start guide - Dutch - 4 pages

Whirlpool ARC 7558 IX User Manual - Dutch - 6 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info