515834
16
Zoom out
Zoom in
Previous page
1/18
Next page
37
4. Connecting the Cable
Indoor Unit
Connect the power cord to the indoor unit by connecting the wires
to the terminals on the control board individually in accordance with
the outdoor unit connection.
NOTE:
It is necessary to remove the cabinet to perform connections with
the indoor unit terminal.
Outdoor Unit
-
Remove the access door from the unit by loosening the screw.
Connect the wires to the terminals on the control board individually
as follows.
-
Secure the power connecting cord on the control board with a cable
clamp.
-
Refit the access door in the original position and tighten the screw.
-
Use a recognized circuit breaker for 24 K model between the power
source and the unit. A disconnecting device to adequately disconnect
all supply lines must be fitted.
CAUTION:
1. Use an individual power circuit specifically for the air
conditioner. As for the wiring method, refer to the circuit
diagram on the inside of the access door.
2. Check that the cable thickness conforms to the power
source specification.
(See the cable specification table below)
3. Check the wires and make sure that they are all tightly
fastened after cable connection.
4. Be sure to install an earth leakage circuit breaker in a wet
or moist area.
Cable Specifications
Attention:
Accessibility to the plug must be guaranteed even after the installation of the appliance to disconnect it
in case of need. If not possible, connect appliance to a double-pole switching device with contact
separation of at least 3 mm
2
placed in an accessible position even after installation.
Front panel
Terminal (inside)
Cabinet
Chassis
Indoor Unit
Outdoor Unit
Access
door
Terminal
(inside)
Capacity
(Btu/h)
Power cord Power connecting cord
Power connecting cord
(for heat pump)
Main
power
supply
Type
Normal cross
- section area
Type
Normal cross
- section area
Type
Normal cross
- section area
7 K-9 K-12 K H05VV-F
1.0-1.5 mm
2
X 3
H07RN-F
1.5 mm
2
X 3
H05RN-F
0.75 mm
2
X 2
To indoor
18 K H05VV-F
1.5-2.0 mm
2
X 3
H07RN-F
1.5 mm
2
X 3
H05RN-F
0.75 mm
2
X 2
To indoor
24 K H07RN-F
2.5 mm
2
X 3
H07RN-F
1.5 mm
2
X 3 (heat pump)
H05RN-F
0.75 mm
2
X 3
To outdoor
2.5 mm
2
X 4 (cool only)
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool AMD 009 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool AMD 009 in the language / languages: English as an attachment in your email.

The manual is 1,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool AMD 009

Whirlpool AMD 009 User Manual - German - 18 pages

Whirlpool AMD 009 User Manual - Dutch - 18 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info