660516
1
Zoom out
Zoom in
Previous page
1/12
Next page
EN -1-
Whirlpool is a registered trademark of Whirlpool USA
Chart
5019 300 00743
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
SALT INDICATOR
When lit (at the end of the cycle), the
salt reservoir needs to be refilled.
WASH TIME DISPLAY
Indicated the cycle duration and the remaining time (h:min). With “Delayed start” selected
it indicates the time remaining until program start (h.00) - below 1h (0:min).
If “Fx Ey” messages appears on the display, see page 9 - chapter “What to do if...”.
PROGRAM
SELECTION
BUTTON
Push “P” button
(repeatedly) until selected
program number is shown
on the display (P1...Px) -
see “Table of programs” -
next page).
HALF LOAD
BUTTON
Half load cycle can be
used for the upper or
lower rack. Select the
required program then
press the “Half Load”
button - the light comes
on. Turns off at the end of
the program.
The “Half Load” option
can be used with the
programs indicated in the
table of programs.
DELAYED START
BUTTON
Push the button
(repeatedly) to delay the
start of the program.
Adjustable from 1 to 24
hours. With each press of
the button, the delayed
start indicator increases
by one hour and after
24 restarts from 0. Then
press the START button.
The dishwasher will start
after the set time.
POWER CLEAN
Thanks to the additional
power jets this option
provides a more intensive
and powerful wash in the
lower rack, in the specific
area. This option is
recommended for
washing pots and
casseroles (see page 7).
Press this button to
activate Power Clean
(the indicator lights up).
For non Power Clean
loading to achieve best
cleaning performances
and resources
optimization, Power
Clean should be switched
off.
TABLET SETTING
This setting allows to
optimize the cycle
performances according
the type of detergent
used. Push the Tablet
button for 3 seconds (until
the indicator lights up)
if you are using the
combined detergents in
tablet (rinse aid, salt and
deteregent in 1 dose).
If you are using powder
detergent or liquid
detergent, the Tablet
indicator on the control
panel has to be off.
START/RESUME
BUTTON
Push this button to start
the selected program: the
indicator lights up and
goes off at the end of the
program.
When the door is opened
during a washing cycle, the
cycle is temporarily
paused: the Start indicator
blinks.
To resume the cycle close
the door and push Start
button again.
CANCEL/OFF
BUTTON
Push this button to switch
off the control panel.
If pressed when a
program is running it
cancels the program
ongoing draining water for
1 minute (0:01 is shown
into the display).
If pressed when the
dishwasher is switched
off, it drains any possible
liquids from dishwasher
(1 minute process).
Quick reference guide
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool ADPU 8793 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool ADPU 8793 in the language / languages: English as an attachment in your email.

The manual is 3,81 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info