651165
8
Zoom out
Zoom in
Previous page
1/8
Next page
n
001
Whirlpool® is a registered trademark of Whirlpool, USA.
Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
PROBLEMS POSSIBLE CAUSES SOLUTIONS
The dishwasher
won’t start or
does not respond
to commands.
The appliance has not been plugged
in properly.
Insert the plug into the socket.
Power outage. The dishwasher starts automatically when the power returns.
The dishwasher door is not closed. Vigorously push the door until you hear the click”.
It does not respond to commands.
Switch o the appliance by pressing the ON/OFF button, switch it
back on after approximately one minute and reset the program.
The dishwasher
won’t drain.
The wash cycle has not nished yet. Wait until the wash cycle nishes.
The drain hose is bent. Check that the drain hose is not bent
(see Installation).
The sink drain pipe is blocked. Clean the sink drain pipe.
The lter is clogged up with food
residues.
Clean the lter (
see Cleaning the Filter Assembly).
The dishwasher
makes excessive
noise.
The dishes are rattling against each Position the crockery correctly
(see Loading the Racks).
An excessive amount of foam has
been produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers
(see Filling the Detergent Dispenser).
Do not pre-wash the dishes by hand.
The dishes are not
clean.
The crockery has not been arranged
properly.
Arrange the crockery correctly
(see Loading the Racks).
The spray arms cannot rotate freely,
being hindered by the dishes.
Arrange the crockery correctly
(see Loading the Racks).
The wash cycle is too gentle. Select an appropriate wash cycle using the Program Table.
An excessive amount of foam has
been produced.
The detergent has not been measured out correctly or it is not
suitable for use in dishwashers
(see Filling the Detergent Dispenser).
The cap on the rinse aid compart-
ment has not been shut correctly.
Make sure the cap of the Rinse Aid dispenser is closed.
The lter is soiled or clogged. Clean the lter assembly
(see Care and Maintenance).
There is no salt. Fill the salt reservoir (see Filling the Rinse Aid Dispenser).
TROUBLESHOOTING
MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, maintenance procedures and trouble-
shooting, see the Use and Care Guide
The Use and Care Guide can be obtained by:
After-Sales Service; phone number see in warranty booklet.
download from Whirlpool website: http://docs.whirlpool.eu
use QR code
IEC 436
:
CONTACTING AFTER-SALES SERVICE
When you contact the After-Sales Service, you must
provide the codes shown on
the rating plate attached to
the left or right side inside the
door of the dishwasher. The
phone number is listed in the
warranty booklet or on the
website:
http://www.whirlpool.eu
TECHNICAL DATASHEET
The technical data containing the energy consumption data
can be downloaded from the Whirlpool website
http://docs.whirlpool.eu
EN
195139916.02
05/2016 jk - Xerox Fabriano
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Whirlpool ADPU 502 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Whirlpool ADPU 502 in the language / languages: English as an attachment in your email.

The manual is 2,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Whirlpool ADPU 502

Whirlpool ADPU 502 Installation Guide - English, Danish, Swedish, Norwegian, Finnish - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info