If pressed when a program is running it cancels the
program ongoing draining water for 1 minute
(0:01 is shown into the display).
If pressed when the dishwasher is switched off,
it drains any possible liquids from dishwasher
(1 minute process).
START/RESUME BUTTON
Push this button to start the selected program: the
indicator lights up and goes off at the end of the
program.
When the door is opened during a washing cycle,
the cycle is temporarily paused: the Start indicator
blinks. To resume the cycle close the door and
push Start button again.
1)Program data obtained in conformity with European standard EN 50242, obtained under normal conditions (without any options) and may vary depending on
conditions. Differences of up to 20 minutes are possible with sensor programs as a result of the appliance’s automatic calibration system.
2)Reference program for energy label in compliance with EN 50242 regulations. - Note for Testing Institutes: for detailed information on the
EN/Standard loading comparison test and other tests, contact the following address: “contact@whirlpool.com”.
*Power consumption in Left-on mode: 1.50 W / Off-mode: 0.50 W
Table of programs
Deter-
gent
Consumption
Drying
Phase
Programs
Available
options
Loading instructions
LitreskWh
Minutes
1)
P1
Sensor40-70°C
Delay
Hygiene
1/2 Load
Recommended program for routine
washes, with dried-on food.
X7-151.00.1.7070-172Full
P2
Pre-Washcold
DelayCrockery to be washed later.—4.00.0114-16NO
P3
Rapid45°C
Delay
Lightly soiled crockery, with no dried-
on food.
X11.00.8530-50NO
P4
Eco
2)
50°C
Delay
Hygiene
1/2 Load
Normally soiled crockery.
Standard program, the most efficient
in terms of its combined energy and
water consumption.
X10.00.922250Full
P5
Daily60°C
Delay
Hygiene
1/2 Load
Normally to heavily soiled crockery.X11.01.3080-95Full
P6
Steam
Delay
Hygiene
Program including steam action
dedicated for heavily soiled crocery,
pots and pans. Soaking or hand
pretreatment is no longer needed.
X14.51.75180-190Full
400010769002
BEFORE USING THE APPLIANCE FOR THE FIRST TIME CAREFULLY READ THIS
QUICK REFERENCE GUIDE AND THE ASSEMBLY INSTRUCTIONS!
Options and display description
SALT INDICATOR
When lit (at the end of the cycle),
the salt reservoir needs to be
refilled.
RINSE AID INDICATOR
When lit (at the end of the cycle),
the rinse aid dispenser needs to
be refilled.
THE CONTROL PANEL OF THIS DISHWASHER ACTIVATES PUSHING ANY
BUTTON EXCEPT CANCEL/OFF BUTTON.
FOR ENERGY SAVING THE CONTROL PANEL DEACTIVATES
AUTOMATICALLY AFTER 30 SECONDS IF NO CYCLE HAS STARTED.
1/2 LOAD BUTTON
Half load cycle can be used for
the upper or lower rack.
Select the required program
then press the “Half Load”
button - the light comes on.
Turns off at the end of the
program.
The ˝Half Load˛ option can be
used with the programs
indicated in the table of
programs.
TABLET SETTING
This setting allows to
optimize the cycle
performances according the
type of detergent used.
Push the Tablet button for
3 seconds (until the indicator
lights up) if you are using the
combined detergents in
tablet (rinse aid, salt and
detergent in 1 dose). If you
are using powder detergent
or gel detergent, the Tablet
indicator on the control
panel has to be off.
DELAYED START BUTTON
Push the button
(repeatedly) to delay the
start of the program –
delay indicator turns on.
Adjustable from 1 to
24 hours. With each press
of the button, the delay
increases by one hour and
after "h 24" returns to
"h 00”. When this option
is selected the delay
indicator turns on. Then
press the START button.
The dishwasher will start
after the set time.
HYGIENE
This function activates an antibacterial rinse at the end of the wash
cycle, guaranteeing a further reduction of bacteria. Press the button
to activate or deactivate the function.
This function can be used with the programs indicated in the table of
programs. The dishwasher door must be kept shut for the entire
duration of the program in order to guarantee reduction of bacteria.
If the door is opened the indicator lamp starts flashing.
WASH TIME DISPLAY
Indicated the cycle
duration and the
remaining time (h:min).
With “Delayed start”
selected it indicates the
time remaining until
program start (h.00) -
below 1h (0:min).
If “Fx Ey” messages
appears on the display,
see page 6 - chapter
“What to do if...”.
Reference guide
Whirlpool is a registered trademark of Whirlpool USA
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Whirlpool ADPU 300 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Whirlpool ADPU 300 in the language / languages: English as an attachment in your email.
The manual is 3,47 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.